TrakMotive FD-8168XTT CV Axle Shaft - Front Left

Extended Travel CV Axle for Ford Ranger

TrakMotive FD-8168XTT is an extended travel CV axle shaft built for front left applications on select Ford Ranger, Mazda B4000, Explorer, Explorer Sport, and Explorer Sport Trac models. It is designed for lifted or stock suspensions and for on-road or off-road use where additional suspension movement demands more CV articulation.

The Extended Travel CV Axle Shaft line adds more operating range than a standard OE-style shaft, helping maintain driveline engagement through suspension travel. For shoppers searching for a Ford Ranger front left CV axle, Mazda B4000 CV axle shaft, or Explorer Sport Trac extended travel axle, FD-8168XTT is a direct-fit replacement for the listed applications.

Key Features

• Extended Travel CV Axle Shaft from TrakMotive
• Sliding center bar design provides up to 44 mm more travel than an OEM CV shaft
• CV joints allow up to 47 degrees of articulation versus a typical 23-degree OE joint angle
• New axle assembly with 27 inboard splines and 27 outboard splines
• Neoprene boot material for the CV joint assembly
• Includes axle nut with M22 x 1.5 thread, 31.8 mm hex size, and self-locking design
• Front left position for select Ford and Mazda applications
• Overall compressed length: 22.56 in. (573 mm)

Product Details

TrakMotive FD-8168XTT is part of the Extended Travel CV Axle Shaft product line, engineered for vehicles that need greater suspension articulation without losing axle engagement. The sliding center bar and high-angle CV joint design help the shaft operate through increased suspension movement, which is especially relevant for lifted trucks and SUVs or vehicles used on rough terrain. This part cross-references Cardone Reman 60-2168 and Dayco 71599 for the same application.

Compatible With 2003-2011 Ford Ranger, front left; 2004-2010 Mazda B4000, front left; 2003-2005 Ford Explorer Sport Trac, front left; 2002-2003 Ford Explorer, front left; and 2002-2003 Ford Explorer Sport, front left. Part number FD-8168XTT is also referenced in interchange listings for related aftermarket applications.

Common Problems This Axle Can Address

• Front axle binding during suspension droop on lifted vehicles
• CV joint angle limitations after suspension modifications
• Axle shaft length issues caused by increased travel demand
• Noise or vibration from a worn front left CV axle assembly
• Loss of smooth driveline operation on rough roads or off-road terrain

Installation Notes

Verify spline count, axle nut thread size, and compressed length before installation. This front left axle is listed for select Ford Ranger, Mazda B4000, Explorer, Explorer Sport, and Explorer Sport Trac applications, including notes for certain 2002 models built from 3/4/02. Always replace in pairs where the vehicle service procedure calls for matched axle service, and confirm all fitment details against the vehicle build information before installation.

Quality Assurance

TrakMotive manufactures this axle as a new replacement component with application-specific dimensions and hardware details documented for fitment verification. The Extended Travel CV Axle Shaft line is built to support higher articulation demands than a typical OE shaft while maintaining the specified vehicle fitment.