TrakMotive FD-8274XTT CV Axle Shaft - Front Right

Extended Travel CV Axle Shaft for Ford F-150

TrakMotive FD-8274XTT is an extended travel CV axle shaft built for the front right position on 2010-2014 Ford F-150 Raptor applications. It is engineered for lifted or stock suspensions and for on-road or off-road use where added articulation and suspension travel are needed.

The TrakMotive Extended Travel CV Axle Shaft line adds more operating range than a standard OE-style axle, with a sliding center bar and increased CV joint articulation. For Ford F-150 front right service, FD-8274XTT provides a direct driveline replacement focused on suspension movement and joint angle capacity.

Key Features

• Part number FD-8274XTT
• Fits 2010-2014 Ford F-150, front right
• Extended Travel CV Axle Shaft from TrakMotive
• Sliding center bar design for increased axle travel
• Up to 44 mm more travel than a typical OEM CV shaft
• Up to 47-degree CV joint articulation angle
• Neoprene boot material
• New axle assembly with included axle nut
• Hex axle nut head, M10 x 1.5 thread
• Inboard joint type: female; outboard joint type: conventional

Product Details

FD-8274XTT is a front right CV axle shaft for the Ford F-150 Raptor platform, covering 2010-2014 model years. It uses a spline-style shaft connection, 31-2 inboard splines, and 45 outboard splines, with an overall compressed length of 24.84 in (631 mm). The extended travel design is intended for vehicles that see greater suspension movement, helping maintain driveline engagement at higher articulation angles. This part cross-references Dayco 71170 for the same application.

Common Issues This Part Can Address

• Clicking or popping from a worn front right CV joint
• Axle binding after suspension lift changes
• Reduced driveline movement at higher articulation angles
• Vibration or noise from a fatigued CV axle shaft
• Need for a replacement axle on a Ford F-150 Raptor front right application

Installation Notes and Tips

• Verify front right fitment against the vehicle’s year, trim, and suspension setup before installation.
• Inspect hub, differential, and seal surfaces for wear before installing the new axle.
• Replace damaged axle hardware and confirm axle nut torque to factory specifications.
• Check suspension and steering clearance through full droop and compression after installation.
• Always replace in pairs when the opposite side shows similar wear or mileage-related fatigue.

Quality Assurance

TrakMotive manufactures this as a new CV axle shaft for driveline service, with an extended travel design aimed at higher articulation demands. FD-8274XTT is built for Ford F-150 front right applications where added suspension movement is part of the vehicle setup.