TrakMotive GM-8132 CV Axle Shaft - Front Right

CV Axle Shaft for Front Right Service

TrakMotive GM-8132 is a new CV axle shaft for front right applications on select 1995-1999 Chevrolet Cavalier and 1995-1999 Pontiac Sunfire models. It is built with a neoprene boot, a 34-spline inboard connection, and a 33-spline outboard connection for direct driveline service.

Key Features

• Brand: TrakMotive CV Axle Shaft
• Part number: GM-8132
• Fits 1995-1999 Chevrolet Cavalier, front right
• Fits 1995-1999 Pontiac Sunfire, front right
• New axle shaft with conventional outboard joint and male inboard joint
• ABS tone ring included with 48-tooth toothed ring
• Neoprene boot material for driveline protection
• Axle nut included with M20 x 1.5 thread, 30 mm hex size, and self-locking design
• Overall compressed length: 37.74 in. (958.5 mm)

Product Details

TrakMotive GM-8132 is a CV axle shaft engineered for front right driveline replacement on the Chevrolet Cavalier and Pontiac Sunfire within the listed model years. The axle uses a male inboard shaft connection, a conventional outboard shaft connection, and the specified spline counts to match the original application. The included ABS tone ring and 48-tooth toothed ring support vehicles equipped for wheel speed sensing, while the manufacturer notes that ABS axles fit non-ABS applications unless otherwise noted. This part cross-references Cardone New 66-1218 and Remy 92544 for the same application.

Common Repair Uses

• Restores driveline transfer when a worn axle causes vibration or clicking during turns
• Addresses torn boot conditions that can lead to grease loss and joint wear
• Replaces a damaged front right axle on 1995-1999 Chevrolet Cavalier and Pontiac Sunfire models
• Helps correct noise from a failing CV joint under acceleration or steering load
• Supports ABS-equipped service needs when the original axle tone ring is required

Installation Notes

Verify front right position, spline count, axle nut thread size, and compressed length before installation. Inspect hub, bearing, and seal surfaces during replacement, and confirm ABS sensor and tone ring alignment where equipped. Torque the supplied axle nut to the vehicle manufacturer specification and follow proper driveline service procedures.

Quality Assurance

TrakMotive backs this CV axle shaft with a limited lifetime warranty. The manufacturer states that its products are produced by an ISO 9001:1007 and TS 16949:2009 certified company, supporting consistent manufacturing control for GM-8132.