TrakMotive HO-8682 CV Axle Shaft - Front Left

Honda Civic Front Left CV Axle Shaft

TrakMotive HO-8682 is a new CV axle shaft for the front left position on select 2016-2020 Honda Civic models. It is built with a neoprene boot, spline connections, and an included axle nut for a direct replacement on the specified application.

Key Features

• Fits 2016-2020 Honda Civic, front left
• TrakMotive AAR CV Axle Shaft line
• New replacement axle shaft for driveline service
• Neoprene boot material for joint protection
• Male inboard joint with spline shaft connection
• Conventional outboard joint design with spline connection
• Includes axle nut with M24 x 1.5 thread size
• No ABS tone ring included
• Overall compressed length: 25.51 in. (648 mm)

Product Details

HO-8682 is engineered for the front left side of the Honda Civic and cross-references OE part number 44306TEXY01 for the same application. The axle uses 27 inboard splines and 28 outboard splines, with a hex-style axle nut and stake locking type. TrakMotive’s AAR CV Axle Shaft line focuses on replacement driveline components built for direct-fit service on covered applications, and this part number HO-8682 follows that approach for the 2016-2020 Honda Civic, front left.

Common Problems This Part Can Address

• Clicking or popping during turns from a worn CV joint
• Vibration or shudder during acceleration
• Grease leakage from a damaged axle boot
• Noise from a worn or damaged front axle assembly
• Driveline play caused by spline or joint wear

Installation Notes

Verify front left fitment before installation and confirm spline count, axle nut thread size, and compressed length against the removed part. Inspect the hub, seals, and surrounding driveline components during service, and replace any worn hardware or damaged mating parts as needed. Because this axle is listed without an ABS tone ring, confirm the vehicle’s original configuration before ordering.

Quality Assurance

TrakMotive states that this CV axle shaft is backed by a limited lifetime warranty. The manufacturer also notes ISO 9001:1007 and TS 16949:2009 certification, supporting controlled production and quality management for replacement driveline parts.