TrakMotive MI-8112 CV Axle Shaft - Front Right

Front Right CV Axle Shaft for Mirage

TrakMotive MI-8112 is a new CV axle shaft for the front right position on 1997-2002 Mitsubishi Mirage models. It is built for direct replacement service on Mirage driveline applications and includes the axle nut and ABS tone ring details needed for the listed configuration.

Key Features

• Fits 1997-2002 Mitsubishi Mirage, front right
• New CV axle shaft from TrakMotive
• 25 inboard splines and 25 outboard splines
• Overall compressed length: 36.85 in. (936 mm)
• Neoprene boot material for CV joint protection
• Male inboard shaft connection with conventional outboard joint type
• ABS tone ring included with 43-tooth toothed ring
• Axle nut included: M22 x 1.5 thread, 32 mm hex, cotter pin locking type

Product Details

This TrakMotive CV axle shaft, part number MI-8112, is specified for the front right side of the Mitsubishi Mirage from 1997 through 2002. The axle uses a male inboard connection, a conventional outboard joint, and a neoprene boot to support driveline operation in the listed application. The included ABS tone ring and 43-tooth ring count are important details for vehicles equipped with the matching sensor setup. TrakMotive MI-8112 is a direct-fit driveline replacement for Mirage owners servicing worn or noisy front axle assemblies.

This part cross-references Monroe Shocks & Struts (e.g., 239112) for the same application.

What This Part Helps Address

• Clicking or popping from a worn front CV joint
• Vibration during acceleration from a damaged axle shaft
• Grease leakage caused by a compromised CV boot
• ABS warning concerns tied to a missing or incorrect tone ring
• Excessive drivetrain play in the front right axle assembly

Installation Notes and Tips

Verify spline count, axle length, and axle nut thread size before installation. Confirm the vehicle’s ABS configuration and tone ring requirements, since ABS axles fit non-ABS applications unless otherwise noted by the manufacturer. Use the correct 32 mm axle nut hex size and follow service procedures for cotter pin retention and torque specifications.

Quality Assurance

TrakMotive manufactures this CV axle shaft as a new replacement part and identifies the product line under ISO 9001:1007 and TS 16949:2009 certified quality systems. The MI-8112 is backed by a limited lifetime warranty.