TrakMotive MI-8127 CV Axle Shaft - Rear Right

Rear Right CV Axle Shaft for Mitsubishi Endeavor

TrakMotive MI-8127 is a new CV axle shaft for rear right applications on the Mitsubishi Endeavor. It is built with a neoprene boot, a toothed ABS ring with 43 teeth, and a supplied axle nut for a direct replacement on the listed vehicles.

Key Features

• Fits 2004-2008 Mitsubishi Endeavor, rear right
• Fits 2009-2011 Mitsubishi Endeavor, rear right, standard duty replacement
• New CV axle shaft from TrakMotive
• Part number MI-8127
• 28 inboard splines and 25 outboard splines
• Overall compressed length: 34.25 in. (870 mm)
• Neoprene boot material for driveline protection
• ABS tone ring included; 43-tooth toothed ring
• Axle nut included: M22 x 1.5, hex, cotter pin locking type

Product Details

TrakMotive MI-8127 is a CV axle shaft for Mitsubishi Endeavor rear right fitments across 2004-2011 model years. The axle uses a male inboard connection, a conventional outboard joint, and the specified spline counts to match the listed applications. For shoppers searching for a rear right CV axle shaft for 2004-2008 Mitsubishi Endeavor or a standard duty replacement CV axle shaft for 2009-2011 Mitsubishi Endeavor, this part number provides a direct fit reference.

TrakMotive’s CV Axle Shaft line focuses on replacement driveline components built for application-specific fitment. MI-8127 follows that approach with the correct compressed length, ABS tone ring setup, and axle nut specification for the covered Mitsubishi Endeavor applications. This part cross-references Dayco 89716 for the same application.

Common Problems This Part Can Address

• Clicking or popping from a worn CV joint
• Vibration during acceleration from a damaged axle shaft
• Boot failure that has allowed grease loss and contamination
• ABS warning concerns related to a damaged tone ring setup
• Excessive driveline play on the rear right side

Installation Notes and Tips

Verify rear right fitment by year, model, and axle configuration before installation. Confirm spline count, compressed length, and axle nut thread size match the removed part. Inspect the hub, seals, and surrounding suspension components during replacement, and torque the axle nut to the vehicle manufacturer’s specification.

Quality Assurance

TrakMotive manufactures this axle as a new replacement part and backs it with a limited lifetime warranty. The company is ISO 9001:1007 and TS 16949:2009 certified, supporting consistent production and quality control for driveline and axle components.