TrakMotive MI-8140 CV Axle Shaft - Front Left

CV Axle Shaft for Sebring and Stratus

TrakMotive MI-8140 is a new CV axle shaft built for front left applications on select Chrysler Sebring and Dodge Stratus models. It is engineered with a neoprene boot, a toothed ABS tone ring, and a self-locking axle nut to support a direct driveline replacement.

Key Features

• New CV axle shaft for front left installation
• Fits 2000-2006 Chrysler Sebring, front left
• Fits 2001-2006 Dodge Stratus, front left
• 46-tooth toothed ABS ring with tone ring included
• Male inboard shaft connection with 25 inboard splines
• Conventional outboard joint with 26 outboard splines
• Neoprene boot material for driveline protection
• Includes axle nut with M22 x 1.5 thread, 32 mm hex size, and self-locking design
• Overall compressed length: 24.25 in. (616 mm)

Product Details

TrakMotive CV Axle Shaft MI-8140 is a direct replacement driveline component for front left service on Chrysler Sebring and Dodge Stratus vehicles listed above. The axle is built new, not remanufactured, and uses a male inboard connection with a conventional outboard joint for the specified applications. The ABS setup includes a 46-tooth toothed ring and tone ring, which supports vehicles equipped for wheel speed sensing. This part cross-references Dayco 72509 for the same application.

Common Problems This Part Helps Address

• Clicking or popping noises during turns from a worn CV joint
• Vibration or shudder during acceleration from axle wear
• Grease leakage caused by a damaged CV boot
• ABS warning concerns related to a damaged tone ring or axle sensor interface
• Excessive driveline play from spline or joint wear

Installation Notes and Tips

Verify front left fitment, spline count, axle length, and axle nut thread size before installation. The included axle nut uses a 32 mm hex and M22 x 1.5 thread. Because ABS axles fit non-ABS applications unless otherwise noted, confirm the vehicle’s brake and sensor configuration before ordering. Inspect the hub, seals, and mating components during replacement to help ensure proper axle seating and smooth operation.

Quality Assurance

TrakMotive backs this CV axle shaft with a limited lifetime warranty. The manufacturer states that its products are produced by an ISO 9001:1007 and TS 16949:2009 certified company, supporting consistent manufacturing and quality control practices.