TrakMotive MZ-8019 CV Axle Shaft - Front Right

CV Axle Shaft for Kia Sephia Front Right

TrakMotive MZ-8019 is a new CV axle shaft for the front right position on 1995-1997 Kia Sephia models. It is built for direct replacement service with the correct spline counts, ABS tone ring, and included axle nut details needed for this application.

Key Features

• Fits 1995-1997 Kia Sephia, front right
• New CV axle shaft for driveline and axle service
• 28-2T inboard spline count and 26 outboard splines
• 44-tooth toothed ABS ring with tone ring included
• Neoprene boot material for joint protection
• Includes axle nut with M22 x 1.5 thread, 31.8 mm hex size, and stake locking type
• Overall compressed length: 24.17 in. (614 mm)

Product Details

TrakMotive CV Axle Shaft MZ-8019 is engineered for the front right side of the Kia Sephia and matches the listed OE-style dimensions and connection points for this application. The axle uses a female inboard connection, a conventional outboard joint, and an ABS tone ring setup with 44 teeth. TrakMotive’s CV Axle Shaft line focuses on replacement driveline components built for accurate fitment and consistent service in passenger vehicle applications.

This part cross-references Cardone New 66-8112 and ACI 87302 for the same application.

Common Repair Applications

• Front right axle noise or vibration during acceleration
• Clicking or binding from worn CV joints
• ABS-related concerns tied to a damaged tone ring or sensor signal path
• Grease leakage from a deteriorated axle boot
• Driveline lash or uneven power transfer at the front axle

Installation Notes

Verify spline count, axle length, and axle nut thread size before installation. Confirm the ABS ring configuration matches the vehicle’s original setup, and inspect hub, bearing, and seal surfaces during replacement. Proper torque procedures and axle nut staking are important for secure installation on this front right Kia Sephia application.

Quality Assurance

TrakMotive backs this CV axle shaft with a limited lifetime warranty. The manufacturer also notes ISO 9001:1007 and TS 16949:2009 certification, supporting controlled production and quality management for replacement driveline parts.