TrakMotive MZ-8051 CV Axle Shaft - Front Right

CV Axle Shaft for Mazda Millenia

TrakMotive MZ-8051 is a new CV axle shaft for the front right position on select Mazda Millenia models. It is built with a neoprene boot, a female inboard connection, and a conventional outboard joint to support smooth driveline operation and consistent power transfer.

This Mazda Millenia front right CV axle shaft includes a 44-tooth toothed ABS ring with tone ring, plus the axle nut needed for installation. TrakMotive MZ-8051 is engineered for 1995-2002 Mazda Millenia applications, with a 1995 front right fitment noted for chassis number 138177 and later 1995-2002 coverage for the same position.

Key Features

• Part number: MZ-8051
• New CV axle shaft for the front right side
• Fits 1995-2002 Mazda Millenia, front right
• Includes a 44-tooth toothed ABS ring and ABS tone ring
• Neoprene boot material for driveline protection
• Female inboard shaft connection and conventional outboard joint
• Axle nut included with M22 x 1.5 thread, stake locking type
• Overall compressed length: 23.23 in. (590 mm)
• ISO 9001:1007 and TS 16949:2009 certified manufacturing

Product Details

TrakMotive MZ-8051 is a direct-fit driveline replacement for Mazda Millenia front right applications. The axle uses a 28-spline outboard connection and a 28-2T inboard spline configuration, with a 31.8 mm hex axle nut and 20 mm nut height. Its 23.23-inch compressed length helps match the original axle geometry for proper suspension travel and driveline alignment.

This part cross-references Cardone New 66-8075 and Cardone Reman 60-8075 for the same application. If you are searching for a front right CV axle shaft for a 1995-2002 Mazda Millenia, MZ-8051 is the cataloged replacement to review.

Common Problems This Part Can Address

• Clicking or popping during turns from a worn CV joint
• Vibration during acceleration caused by axle wear
• Torn or deteriorated axle boot allowing grease loss
• ABS warning concerns related to a damaged tone ring or ring tooth count mismatch
• Driveline noise from excessive axle play or joint wear

Installation Notes and Tips

Verify front right fitment against the vehicle year and chassis note before installation. Confirm the axle nut thread size, hex size, and locking style match the original hardware, and inspect the hub, seals, and mating components for wear before installing the new axle. Proper torque procedures and final ABS system checks are recommended after replacement.

Quality Assurance

TrakMotive manufactures this CV axle shaft as a new replacement part under ISO 9001:1007 and TS 16949:2009 certified quality systems. MZ-8051 is backed by a limited lifetime warranty.