TrakMotive MZ-8206 CV Axle Shaft - Rear Left

TrakMotive MZ-8206 Rear Left CV Axle Shaft

The TrakMotive MZ-8206 is a new rear left CV axle shaft for the 2004-2011 Mazda RX-8. Built for direct replacement service, it combines the correct spline counts, ABS tone ring setup, and axle nut specifications for a precise driveline repair.

TrakMotive CV Axle Shaft products are built for application-specific fitment and consistent replacement performance. For Mazda RX-8 rear axle service, the MZ-8206 follows the required OE-style dimensions and connection details for the rear left position.

Key Features

• Fits 2004-2011 Mazda RX-8, rear left
• New CV axle shaft for driveline and axle repair
• Inboard joint type: male
• Outboard joint type: conventional
• 26 inboard splines and 28 outboard splines
• ABS tone ring included with 44-tooth toothed ring
• Neoprene boot material
• Axle nut included with M24 x 1.5 thread size
• Overall compressed length: 30.24 in. (768 mm)

Detailed Description

The TrakMotive MZ-8206 CV axle shaft is engineered for the rear left side of the Mazda RX-8 from 2004 through 2011. It uses a male inboard shaft connection, a spline-style outboard connection, and the specified spline counts to match the vehicle’s driveline requirements. The included ABS tone ring uses a toothed design with 44 teeth, supporting applications that require ABS signal compatibility. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

As a direct replacement axle for Mazda RX-8 rear axle service, MZ-8206 is built to restore proper power transfer between the differential and wheel hub while maintaining the correct fitment dimensions. The neoprene boot material and new construction support routine axle replacement on vehicles showing wear at the CV joints or shaft assembly.

What It Helps Address

• Clicking or popping noises from a worn CV joint
• Vibration during acceleration from a damaged axle shaft
• ABS warning concerns related to a failed tone ring or sensor signal issue
• Grease leakage from a deteriorated axle boot
• Driveline noise caused by spline or joint wear

Installation Notes and Tips

Verify rear left fitment before installation on 2004-2011 Mazda RX-8 models. Confirm axle nut thread size, spline count, and ABS tone ring requirements against the removed part before assembly. Use the included axle nut only if it matches the vehicle’s service specification, and follow factory torque procedures during installation.

Quality Assurance

TrakMotive lists this CV axle shaft as a new part from an ISO 9001:1007 and TS 16949:2009 certified company. The MZ-8206 also carries a limited lifetime warranty.