TrakMotive NI-8005 CV Axle Shaft - Front Left

CV Axle Shaft for Infiniti G20 Front Left

TrakMotive NI-8005 is a new CV axle shaft for front left applications on select 1991-1996 Infiniti G20 models. It is built with a neoprene boot, a 42-tooth toothed ABS ring, and a supplied axle nut for a direct replacement on the listed vehicles.

For Infiniti G20 owners searching for a front left CV axle shaft, NI-8005 provides the correct spline and joint configuration for the specified fitment. This TrakMotive CV axle shaft is engineered for 1991-1992 and 1993-1996 Infiniti G20 applications, including 1993-1996 models without limited slip differential.

Key Features

• Brand: TrakMotive CV Axle Shaft
• Part number: NI-8005
• New replacement axle shaft
• Front left position
• Neoprene boot material
• 42-tooth toothed ABS ring with ABS tone ring included
• Male inboard joint and conventional outboard joint
• 25 inboard splines and 27 outboard splines
• Overall compressed length: 24.45 in. (621 mm)
• Axle nut included, M24 x 1.5 thread, 34.64 mm hex size

Product Details

TrakMotive NI-8005 is a CV axle shaft built for driveline service on the Infiniti G20 front left side. The axle uses a male inboard shaft connection and a conventional outboard shaft connection, with spline counts and compressed length matched to the listed applications. The ABS tone ring is included, and the axle nut specifications are provided for proper service planning. This part cross-references Cardone New 66-6075 for the same application.

What This Part Helps Address

• Clicking or popping during turns caused by worn CV joints
• Vibration from a damaged or unbalanced axle shaft
• Grease leakage from a torn or deteriorated boot
• ABS warning concerns related to a damaged tone ring area
• Driveline noise from excessive axle wear

Installation Notes and Tips

Verify the vehicle’s transmission, differential, and ABS configuration before installation. This axle fits non-ABS applications unless otherwise noted, and 1993-1996 Infiniti G20 listings specify use without limited slip differential. Confirm spline count, axle length, and axle nut thread size against the removed part before assembly. Use the correct torque procedure for the axle nut and inspect related hub and suspension components during replacement.

Quality Assurance

TrakMotive manufactures this CV axle shaft as a new part and identifies the line as ISO 9001:1007 and TS 16949:2009 certified. NI-8005 is backed by a limited lifetime warranty.