TrakMotive NI-8021 CV Axle Shaft - Front Left

CV Axle Shaft for Nissan Sentra Front Left

TrakMotive NI-8021 is a new front left CV axle shaft built for select Nissan Sentra, 200SX, and NX applications. It is engineered with the correct spline counts, ABS tone ring details, and axle nut specifications needed for direct replacement service on covered vehicles.

Key Features

• New TrakMotive CV axle shaft, part number NI-8021
• Fits front left applications on select Nissan Sentra, 200SX, and NX models
• 25 inboard splines and 25 outboard splines
• 42-tooth toothed ABS ring with ABS tone ring included
• Neoprene boot material for driveline protection
• Male inboard shaft connection and conventional outboard joint type
• Overall compressed length: 24.69 in. (627 mm)
• Axle nut included: M22 x 1.5 thread, 31.6 mm hex size, cotter pin locking type

Detailed Description

TrakMotive NI-8021 is a CV axle shaft for front left driveline service on Nissan Sentra, Nissan 200SX, and Nissan NX vehicles listed below. This axle uses a male inboard connection, a conventional outboard joint, and a 24.69-inch compressed length to match the specified application. The included ABS tone ring and 42-tooth toothed ring support ABS-equipped fitments where required, while the neoprene boot helps protect the joint assembly from road contamination.

TrakMotive’s CV Axle Shaft line focuses on replacement driveline components built to match OE-style fitment details. NI-8021 is a direct-fit option for Nissan Sentra front left axle replacement, including 1991-1996 Sentra, 1997 Sentra w/ ABS, 1998-2006 Sentra, 2000-2001 Sentra w/o Limited Slip Differential, 1995-1998 200SX, and 1991-1993 NX applications. This part cross-references Cardone New 66-6163 and GSP NCV53551 for the same application.

What This Axle Shaft Helps Address

• Clicking or popping during turns caused by worn CV joints
• Vibration or shudder from a damaged axle shaft
• Grease leakage from a torn or deteriorated boot
• ABS warning concerns tied to a failed tone ring or incorrect axle configuration
• Driveline noise from excessive spline or joint wear

Installation Notes and Tips

Verify front left fitment, transmission configuration, and ABS requirements before installation. Confirm axle nut thread size, hex size, and locking style against the vehicle’s original hardware. For 1997 Nissan Sentra ABS applications, the included tone ring details are relevant to proper sensor operation. Always inspect hub, seal, and suspension components during axle replacement to help prevent repeat failures.

Quality Assurance

TrakMotive lists this axle shaft as a new component backed by a limited lifetime warranty. The manufacturer also states ISO 9001:1007 and TS 16949:2009 certification, reflecting controlled production and quality management standards.