TrakMotive NI-8029 CV Axle Shaft - Front Left

CV Axle Shaft for Nissan Maxima

TrakMotive NI-8029 is a new front left CV axle shaft for 1985-1994 Nissan Maxima applications. It is built with a 27-spline inboard connection, 27-spline outboard connection, and a 24.53-inch compressed length for direct driveline replacement on the listed vehicles.

Key Features

• Fits 1985-1994 Nissan Maxima, front left
• New CV axle shaft for driveline and axle service
• 27 inboard splines and 27 outboard splines
• Overall compressed length: 24.53 in. (623 mm)
• Neoprene boot material for CV joint protection
• Male inboard shaft connection with conventional outboard joint type
• ABS tone ring included; 46-tooth toothed ABS ring
• Axle nut included: M24 x 1.5, 35.5 mm hex, cotter pin locking type

Product Details

This TrakMotive CV axle shaft is part of the CV Axle Shaft line and is engineered for Nissan Maxima front left service across the 1985-1994 model years. The NI-8029 uses a male inboard connection, a conventional outboard connection, and a neoprene boot to support CV joint sealing in a direct-fit replacement format. The included axle nut and ABS tone ring details make it easier to match the original driveline configuration on the listed Nissan Maxima applications. This part cross-references Cardone New 66-6048 and Cardone Reman 60-6006 for the same application.

Common Repair Uses

• Restoring front-wheel drive power transfer after CV joint wear
• Replacing a clicking or binding axle on acceleration or turning
• Addressing torn boot conditions that can lead to grease loss and contamination
• Correcting vibration or driveline noise from a worn axle assembly
• Servicing a damaged front left axle on a Nissan Maxima

Installation Notes

Verify spline count, compressed length, axle nut thread size, and ABS ring configuration before installation. Confirm the vehicle is a front left Nissan Maxima application from the listed years and inspect related hub, seal, and suspension components during service. Use the specified axle nut and follow factory torque procedures for final assembly.

Quality Assurance

TrakMotive states this axle shaft is a new part backed by a limited lifetime warranty. The manufacturer also notes ISO 9001:1007 and TS 16949:2009 certification, and that ABS axles fit non-ABS applications unless otherwise noted.