TrakMotive NI-8263 CV Axle Shaft - Rear Left or Rear Right

Rear CV Axle Shaft for Nissan Rogue

TrakMotive NI-8263 is a new rear CV axle shaft for Nissan Rogue and Nissan Rogue Select applications. It is built for rear left and rear right positions on listed vehicles, with OE-style dimensions and drivetrain connections for direct replacement service.

Key Features

• Brand: TrakMotive CV Axle Shaft
• Part number: NI-8263
• New axle shaft construction
• Overall compressed length: 31.54 in. (801 mm)
• Inboard joint type: Male
• Outboard joint type: Conventional
• Inboard splines: 21
• Outboard splines: 25
• ABS tone ring included with 48-tooth toothed ring
• Axle nut included: M22 x 1.5, 30 mm hex, cotter pin locking type
• Neoprene boot material

Product Details

This TrakMotive CV axle shaft is engineered for rear driveline service on 2008-2013 Nissan Rogue and 2014-2015 Nissan Rogue Select models. The NI-8263 uses a male inboard connection, a conventional outboard joint, and the specified spline counts to match the listed rear left and rear right applications. ABS-equipped coverage includes a toothed tone ring with 48 teeth, and ABS axles fit non-ABS applications unless otherwise noted by the catalog data.

TrakMotive’s CV Axle Shaft line focuses on replacement driveline components for passenger vehicles, and this part follows that product line with a new-build design and application-specific dimensions. This part cross-references Cardone New 66-6352 for the same application.

Common Problems This Part Can Address

• Clicking or popping from a worn rear CV joint
• Vibration during acceleration from a damaged axle shaft
• Boot failure that has allowed grease loss and contamination
• ABS warning concerns related to a damaged tone ring or sensor interface
• Driveline noise from excessive axle wear on Nissan Rogue rear applications

Installation Notes and Tips

Verify rear left or rear right placement before installation on the Nissan Rogue or Nissan Rogue Select. Confirm spline count, axle nut thread size, and overall compressed length against the removed part before assembly. Use the included axle nut specified for this application and follow factory torque procedures during installation. Inspect the hub, bearings, and surrounding seals for wear before installing the new axle shaft.

Quality Assurance

TrakMotive states that this CV axle shaft is backed by a limited lifetime warranty. The manufacturer also notes ISO 9001:1007 and TS 16949:2009 certification, supporting controlled production and quality management for this replacement driveline component.