TrakMotive NI-8363 CV Axle Shaft - Front Left

CV Axle Shaft for Nissan Juke

TrakMotive NI-8363 is a new CV axle shaft for the front left position on select 2011-2017 Nissan Juke models. It is built for direct replacement service with the correct spline counts, axle nut specification, and overall compressed length for the listed application.

• Fits 2011-2017 Nissan Juke, front left
• Brand: TrakMotive CV Axle Shaft
• Part number: NI-8363
• New axle shaft assembly
• Overall compressed length: 27.19 in. (690.5 mm)
• Inboard joint type: male
• Outboard joint type: conventional
• Inboard splines: 27
• Outboard splines: 29
• Boot material: neoprene
• Axle nut included with cotter pin locking type
• Axle nut thread size: M24 x 1.5

Product Details

This TrakMotive CV axle shaft is part of the CV Axle Shaft line and is engineered for the front left side of the Nissan Juke across the 2011-2017 model years. The NI-8363 uses a male inboard connection, spline-style outboard shaft connection, and a conventional outboard joint configuration to match the listed fitment. It also includes the axle nut specified for the application. ABS tone ring is not included, and TrakMotive notes that ABS axles fit non-ABS applications unless otherwise noted.

For shoppers searching for a front left CV axle for Nissan Juke 2011-2017, NI-8363 provides the key dimensions and connection details needed for a direct replacement selection. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Restores driveline operation after a worn or damaged CV axle
• Addresses clicking or popping during turns caused by joint wear
• Helps correct vibration from a failing front axle shaft
• Replaces a leaking or torn CV boot assembly on the listed application
• Supports repair of axle noise on a Nissan Juke front left driveline

Installation Notes

Verify the front left position, spline count, axle nut thread size, and compressed length before installation. Confirm whether the vehicle is equipped for the listed axle configuration and inspect related components such as wheel hub, seals, and suspension hardware during service. Proper torque procedures should be followed for the axle nut and all related fasteners.

Quality Assurance

TrakMotive manufactures this CV axle shaft as a new replacement part in an ISO 9001:1007 and TS 16949:2009 certified facility. NI-8363 is backed by a limited lifetime warranty.