TrakMotive NI-8688 CV Axle Shaft - Front Left

Front Left CV Axle Shaft for Nissan Rogue Sport and Qashqai

TrakMotive NI-8688 is a new front left CV axle shaft for select Nissan Rogue Sport and Nissan Qashqai applications. It is built with a neoprene boot, spline-style shaft connections, and an included axle nut for a direct driveline service replacement.

Key Features

• Fits 2021 Nissan Rogue Sport, front left
• Fits 2017-2020 Nissan Rogue Sport, front left, updated design
• Fits 2017-2019 Nissan Qashqai, front left, updated design
• New CV axle shaft from TrakMotive AAR CV Axle Shaft line
• Neoprene boot material for driveline protection
• 27 inboard splines and 29 outboard splines
• Male inboard joint with spline connection
• Conventional outboard joint with spline connection
• Axle nut included, M24 x 1.5 thread, cotter pin locking type
• No ABS tone ring included

Detailed Description

The TrakMotive NI-8688 CV axle shaft is engineered for front left service on the Nissan Rogue Sport and Nissan Qashqai listed above. This axle shaft measures 27.95 inches compressed overall length and uses a hex-style axle nut with a 31.8 mm hex size. As a new replacement part, it supports driveline repair where worn joints, damaged splines, or boot failure have affected axle performance. This part cross-references OE numbers 391014BB0B and 391014BB8E for the same application.

The AAR CV Axle Shaft product line focuses on application-specific replacement geometry and hardware details that matter during axle service. For shoppers searching for a front left CV axle shaft for 2017-2020 Nissan Rogue Sport or 2017-2019 Nissan Qashqai, NI-8688 provides the fitment and component specifications needed for a direct replacement decision.

Common Repair Reasons

• Clicking or popping during turns from worn CV joints
• Vibration under acceleration from axle wear or imbalance
• Torn boot conditions that allow grease loss and contamination
• Noise from damaged splines or joint wear
• Front driveline service after axle removal or failure

Installation Notes and Tips

Confirm front left fitment by year, model, and updated-design notes before installation. Verify axle nut thread size, hex size, and locking style against the original hardware. Inspect the hub, seals, and surrounding suspension components during replacement, and make sure the axle seats fully in the transaxle and hub before final torque procedures.

Quality Assurance

TrakMotive manufactures this axle shaft as a new part in an ISO 9001:1007 and TS 16949:2009 certified facility. NI-8688 is backed by a limited lifetime warranty. ABS axles fit non-ABS applications unless otherwise noted.