TrakMotive SB-8005 CV Axle Shaft - Front Left or Front Right

CV Axle Shaft for Driveline Repair

TrakMotive SB-8005 is a new CV axle shaft built for driveline service where a worn axle can cause vibration, clicking, or torque transfer issues. This CV axle shaft uses a neoprene boot, a female inboard connection, and a conventional outboard joint for a direct replacement style repair.

Compatible with select Honda Civic and Acura Integra applications, SB-8005 is a fitment-focused replacement for front axle service where the original shaft has excessive play or boot failure. The included axle nut and 35.5 mm hex size support a straightforward installation on the correct vehicle application.

Key Features

• TrakMotive CV axle shaft, part number SB-8005
• New replacement axle shaft for driveline and axle repair
• Neoprene boot material for joint protection
• Female inboard shaft connection with 25 inboard splines
• Conventional outboard joint with 30 outboard splines
• Overall compressed length: 27.36 in. (695 mm)
• Axle nut included with M24 x 1.5 thread, cotter pin locking type
• ABS tone ring not included

Product Details

SB-8005 is a TrakMotive CV axle shaft from the CV Axle Shaft product line, engineered as a new replacement driveline component for vehicles that require this specific spline count, shaft length, and connection style. The axle uses a female inboard joint and a conventional outboard joint, with a hex axle nut and cotter pin retention. TrakMotive identifies this axle as suitable for non-ABS applications unless otherwise noted, and the part is backed by the company’s ISO 9001:1007 and TS 16949:2009 certified manufacturing standards.

This part cross-references Cardone Reman 60-7009 for the same application.

Common Repair Symptoms

• Clicking or popping during turns
• Vibration during acceleration
• Grease leakage from a damaged CV boot
• Axle shaft play or worn splines
• Noise from a failing front driveline assembly

Installation Notes

Verify spline count, compressed length, axle nut thread size, and ABS requirements before installation. SB-8005 uses a 35.5 mm axle nut hex size and includes a cotter-pin style axle nut; confirm the vehicle’s hub and knuckle setup matches the listed specifications. For best results, inspect seals, wheel bearings, and related suspension components during axle replacement.

Quality Assurance

TrakMotive manufactures this CV axle shaft under ISO 9001:1007 and TS 16949:2009 certified processes. SB-8005 is covered by a limited lifetime warranty.