TrakMotive SB-8010 CV Axle Shaft - Front Left or Front Right

CV Axle Shaft for Subaru Standard

TrakMotive SB-8010 is a new CV axle shaft for front left and front right applications on 1980-1984 Subaru Standard models. It is built with a neoprene boot, a female inboard connection, and a conventional outboard joint for direct driveline service on the listed vehicles.

Key Features

• Fits 1980-1984 Subaru Standard, front right
• Fits 1980-1984 Subaru Standard, front left
• New CV axle shaft for driveline repair and replacement
• Neoprene boot material for CV joint protection
• Female inboard shaft connection style
• Conventional outboard shaft connection style
• 23 inboard splines and 30 outboard splines
• Overall compressed length: 25.47 in. (647 mm)
• Includes axle nut with M24 x 1.5 thread, hex head, and cotter pin locking type
• ABS tone ring not included

Product Details

TrakMotive SB-8010 is a CV axle shaft for Subaru Standard front axle service, covering both front right and front left positions for the listed 1980-1984 applications. The axle uses a female inboard joint, a conventional outboard joint, and a 25.47-inch compressed length to match the specified driveline geometry. TrakMotive identifies this axle as an ABS axle that fits non-ABS applications unless otherwise noted, and this unit does not include an ABS tone ring.

This part cross-references Cardone Reman 60-7001 for the same application. The SB-8010 part number is also used across interchange listings for related Subaru Standard front axle replacement needs.

Common Repair Uses

• Restores a worn or noisy CV axle on Subaru Standard front suspension
• Replaces a damaged axle shaft with spline or joint wear
• Addresses clicking during turns caused by CV joint deterioration
• Corrects vibration from a failing front driveline component
• Supports repair after torn boot or grease loss

Installation Notes

Verify spline count, axle length, and axle nut thread size before installation. Confirm front left or front right position against the vehicle being serviced, and inspect the hub, seals, and mating components for wear before fitting the new axle. Use the included axle nut with the specified cotter pin locking style where required by the application.

Quality Assurance

TrakMotive manufactures this CV axle shaft as a new replacement part and backs it with a limited lifetime warranty. The company states that its products are produced under ISO 9001:1007 and TS 16949:2009 certified quality systems.