TrakMotive TO-8186 CV Axle Shaft - Front Left

CV Axle Shaft for Toyota Sienna

TrakMotive TO-8186 is a new front left CV axle shaft for 2004-2010 Toyota Sienna applications. It is built for direct replacement service on the Toyota Sienna front axle position and includes the ABS tone ring specified for this application.

Key Features

• Fits 2004-2010 Toyota Sienna, front left
• TrakMotive CV Axle Shaft, part number TO-8186
• New replacement axle shaft for driveline service
• 48-tooth toothed ABS ring with tone ring included
• Neoprene boot material for axle joint protection
• Male inboard shaft connection with conventional outboard joint
• Includes axle nut with M22 x 1.5 thread, 32 mm hex size, and stake locking type
• Overall compressed length: 26.93 in. (684 mm)

Product Details

This TrakMotive CV axle shaft is built for the front left position on the Toyota Sienna and follows the OE-style configuration for the listed fitment. The TO-8186 uses a male inboard joint, a conventional outboard joint, 23 inboard splines, and 30 outboard splines to match the specified driveline setup. ABS-equipped and non-ABS applications are addressed by the manufacturer’s fitment guidance, and the included toothed tone ring supports ABS signal requirements where applicable. TrakMotive identifies this part as a new component, not remanufactured, and backs its CV axle shaft line with ISO 9001:1007 and TS 16949:2009 certified manufacturing controls.

This part cross-references Cardone New 66-5250 and Cardone Reman 60-5250 for the same application.

Common Problems This Part Can Address

• Clicking or popping during turns caused by worn CV joints
• Vibration or shudder from a damaged axle shaft
• Torn or deteriorated axle boot conditions
• ABS warning concerns related to a failed tone ring or ring damage
• Driveline noise from excessive axle wear

Installation Notes

• Verify front left fitment on 2004-2010 Toyota Sienna before installation.
• Confirm spline count, axle nut thread size, and hex size against the original part.
• Inspect hub, seals, and surrounding suspension components during axle replacement.
• Use proper torque procedures and stake the axle nut as required by the vehicle.
• Check ABS sensor operation after installation if the vehicle is equipped with ABS.

Quality Assurance

TrakMotive manufactures this CV axle shaft under ISO 9001:1007 and TS 16949:2009 certified quality systems. The TO-8186 is covered by a limited lifetime warranty.