TrakMotive TO-8329 CV Axle Shaft - Rear Left or Rear Right

Rear CV Axle Shaft for Toyota Highlander

TrakMotive TO-8329 is a new CV axle shaft for rear left and rear right applications on select Toyota Highlander models. It is built for USA-built vehicles with the specified VIN breakpoints and includes ABS tone ring details matched to the application.

The TrakMotive CV Axle Shaft line focuses on direct-fit driveline replacement parts for passenger vehicles. TO-8329 follows that approach with application-specific spline counts, axle nut specifications, and compressed length for accurate fitment on the rear axle assembly.

• New CV axle shaft for rear axle service
• Fits Toyota Highlander rear right and rear left applications listed below
• ABS tone ring included with 48-tooth toothed ring
• Neoprene boot material for driveline protection
• Male inboard shaft connection style
• Conventional outboard joint and shaft connection style
• 23 inboard splines and 26 outboard splines
• Overall compressed length: 32.64 in. (829 mm)
• Axle nut included with M22 x 1.5 thread, 30 mm hex size, and stake locking type

Fitment Details

• Fits 2010-2013 Toyota Highlander, rear right, USA Built; VIN K (5th Digit)
• Fits 2010-2013 Toyota Highlander, rear left, USA Built; VIN K (5th Digit)
• Fits 2009-2012 Toyota Highlander, rear right, USA Built; VIN A (5th Digit)
• Fits 2009-2012 Toyota Highlander, rear left, USA Built; VIN A (5th Digit)
• Fits 2008-2009 Toyota Highlander, rear right, USA Built; VIN S (5th Digit)
• Fits 2008-2009 Toyota Highlander, rear left, USA Built; VIN S (5th Digit)

Use TO-8329 when replacing a worn rear CV axle on a Toyota Highlander with the matching USA-built VIN code and rear position. This part cross-references 60-5370 for the same application.

Common Problems This Part Can Address

• Clicking or popping noises from the rear axle during turns
• Vibration felt through the driveline under acceleration
• Torn or deteriorated CV boot condition
• Excessive play in the rear CV axle assembly
• ABS tone ring wear or mismatch on the rear axle

Installation Notes and Quality Assurance

Verify the vehicle’s VIN code, rear position, spline count, and axle nut specifications before installation. Confirm the ABS tone ring configuration matches the original setup on the vehicle. Proper torque procedures and axle nut staking should be followed during installation.

TrakMotive TO-8329 is backed by a limited lifetime warranty. The manufacturer states that ABS axles fit non-ABS applications unless otherwise noted, and that the company is ISO 9001:1007 and TS 16949:2009 certified.