TrakMotive TO-8349 CV Axle Shaft - Rear Left

TrakMotive TO-8349 CV Axle Shaft for Toyota MR2

TrakMotive TO-8349 is a new CV axle shaft for rear left applications on the 1991-1995 Toyota MR2. It is built with a 23.98 in. compressed length, 20 inboard splines, 26 outboard splines, and an included axle nut for a direct driveline service replacement.

Key Features

• Fits 1991-1995 Toyota MR2, rear left
• New CV axle shaft for driveline and axle service
• Overall compressed length: 23.98 in. (609 mm)
• Inboard joint type: male; outboard joint type: conventional
• Boot material: neoprene
• ABS tone ring included with 48-tooth toothed ring
• Axle nut included, M22 x 1.5 thread, 29.8 mm hex size
• TrakMotive TO-8349 cross-references Cardone Reman 60-5074 for the same application

Detailed Description

TrakMotive TO-8349 is a CV axle shaft for the rear left side of the Toyota MR2 from 1991 through 1995. This axle is configured as a new replacement part with a male inboard connection, conventional outboard connection, neoprene boot material, and an ABS tone ring included for vehicles using that setup. The axle nut is included and uses an M22 x 1.5 thread with a 29.8 mm hex size. For buyers searching for a Toyota MR2 rear left CV axle shaft, TO-8349 provides the fitment and dimensional details needed for a direct replacement decision.

TrakMotive’s CV axle shaft line is backed by ISO 9001:1007 and TS 16949:2009 certified manufacturing practices, and the brand states limited lifetime warranty coverage for this part line. If you are replacing a worn Toyota MR2 axle, TO-8349 is the part number to reference during fitment verification and ordering.

Common Problems This Part Can Address

• Clicking or popping from a worn CV joint during turns
• Vibration or shudder from a damaged axle shaft
• Grease leakage from a torn or deteriorated boot
• Excessive driveline play from spline or joint wear
• ABS warning concerns related to a damaged tone ring setup

Installation Notes and Tips

• Verify rear left fitment on the 1991-1995 Toyota MR2 before installation.
• Confirm spline count, axle length, and axle nut thread size against the removed part.
• Inspect hub, seals, and surrounding suspension components for wear before installing the new axle.
• Torque the axle nut to the vehicle manufacturer’s specification during assembly.
• Check ABS sensor and tone ring alignment after installation if the vehicle uses ABS.

Quality Assurance

TrakMotive TO-8349 is a new CV axle shaft from an ISO 9001:1007 and TS 16949:2009 certified company. The manufacturer lists limited lifetime warranty coverage for this product line.