TrakMotive VW-8108 CV Axle Shaft - Front Right

CV Axle Shaft for Volkswagen Front Right

TrakMotive VW-8108 is a new CV axle shaft for the front right position on select 2012-2014 Volkswagen Beetle and 2012-2014 Volkswagen Passat models. It is built for direct driveline replacement where a worn axle can cause vibration, clicking, or torque transfer issues during acceleration and turning.

Key Features

• Brand: TrakMotive CV Axle Shaft
• Part number: VW-8108
• Fits 2012-2014 Volkswagen Beetle, front right
• Fits 2012-2014 Volkswagen Passat, front right
• New axle shaft construction
• Neoprene boot material
• 36 outboard splines
• Bolt-on inboard joint and Audi-style spline bolt outboard connection
• Overall compressed length: 32.34 in. (821.5 mm)
• Axle bolt thread size: M16 x 1.5
• Axle bolt hex size: 27 mm
• ABS tone ring not included

Product Details

This TrakMotive CV axle shaft is engineered for front right driveline service on Volkswagen Beetle and Volkswagen Passat applications listed above. The VW-8108 uses a bolt-on inboard joint, an Audi-style spline bolt outboard connection, and a neoprene boot to support consistent articulation at the suspension and hub. TrakMotive positions this CV axle shaft line as a direct replacement solution for driveline repair, and the part number VW-8108 cross-references OE and aftermarket numbers including 5C0407272AB and 5C0407272AR for the same application.

Common Problems This Part Can Address

• Clicking or popping noises during turns from a worn outer CV joint
• Vibration under acceleration from axle shaft wear or imbalance
• Grease leakage from a damaged CV boot
• Driveline play caused by joint or spline wear
• Front right axle failure on Volkswagen Beetle or Volkswagen Passat models

Installation Notes and Tips

Verify front right fitment by year, model, and axle configuration before installation. Confirm the axle bolt thread size, hex size, and inboard bolt specifications against the vehicle’s original hardware and hub setup. Because ABS tone ring is not included, compare the original axle design before service. Always inspect seals, wheel bearings, and related suspension components while replacing the axle shaft.

Quality Assurance

TrakMotive identifies this CV axle shaft as a new part and states that its manufacturing is supported by ISO 9001:1007 and TS 16949:2009 certification. The manufacturer also backs the part with a limited lifetime warranty.