URO 2024600405 Steering Drag Link - Center

Mercedes-Benz Steering Drag Link Assembly

This URO steering drag link is a direct replacement for select Mercedes-Benz C-Class applications with center steering linkage fitment. Built with OE tie rod geometry and pre-greased joints, it is intended to restore steering response, reduce vibration at the wheel, and maintain proper alignment on the vehicle.

• Fits 1994-1996 Mercedes-Benz C220, center, assembly with tie rods and tie rod ends
• Fits 1994-1997 Mercedes-Benz C280, center, assembly with tie rods and tie rod ends
• Fits 1995-1997 Mercedes-Benz C36 AMG, center, assembly with tie rods and tie rod ends
• Fits 1997-2000 Mercedes-Benz C230, center, assembly with tie rods and tie rod ends
• Male end 1 and male end 2 configuration
• Threaded ball stud design with high-strength steel housing and metal bearing material
• Pre-greased, with neoprene dust boot and black dust boot cover
• Lock nuts included; grease fitting, adjusting sleeve, castle nut, cotter pin, and washers not included
• Bar size: 1.108 in. (28.14 mm); length: 48.7 in.

Built For OE-Style Steering Geometry

Part number 2024600405 is engineered around OE tie rod geometry to support correct wheel alignment and consistent steering feel. For Mercedes-Benz C230, C280, C36 AMG, and C220 center steering linkage service, this drag link replaces worn components that can contribute to loose steering, front-end vibration, and uneven tire wear. This part cross-references VAICO V30-7129 and Beck/Arnley 101-6343 for the same application.

What This Drag Link Helps Address

• Steering wheel vibration caused by worn linkage joints
• Loose or imprecise steering response
• Alignment issues related to worn center steering components
• Noise or play from deteriorated steering linkage joints
• Dust and moisture intrusion at the joint area

Installation Notes

Verify center steering linkage application before installation. This assembly is pre-greased and does not include a grease fitting, so no routine greasing is required. Because the drag link is supplied without an adjusting sleeve, castle nut, cotter pin, or washers, confirm the existing hardware and alignment components are serviceable before beginning the job. A professional alignment is recommended after replacement.

Quality Assurance

URO lists this steering drag link with guaranteed fitment, durable material construction, and a 24 month unlimited mileage warranty. The dust boot uses heat- and ozone-resistant neoprene to help protect the joint from grit and water during normal road use.