VDO A2C59519707Z Fuel Injection Throttle Body Assembly

OE Electronic Throttle Body Assembly

This VDO electronic throttle body assembly is built to OE specifications for precise air management and consistent throttle response. It is a direct-fit replacement for select 2011-2014 Ford F-150 and 2011-2014 Ford Mustang applications, with the VDO A2C59519707Z part number matching the original-style design used in these vehicles.

• 12-volt electric throttle body design
• 82.50 mm maximum air intake port diameter
• Aluminum housing with silver matte finish
• 6-pin male terminal layout with oval connector shape
• Throttle position sensor included
• Idle air control motor included

Fitment and Application

Compatible with 2011-2014 Ford F-150 and 2011-2014 Ford Mustang. Use the VDO A2C59519707Z when replacing a worn or failing electronic throttle body on these applications. This part cross-references Ford service numbers BR3Z9E926A and BR3Z9E926B for the same application.

Detailed Description

VDO manufactures this fuel injection throttle body assembly to match original equipment fit, form, and function. The electric throttle body uses a 12-volt design and includes the throttle position sensor and idle air control motor, helping restore accurate airflow control for smoother engine operation. The aluminum housing and oval 6-terminal connector support a factory-style installation on select Ford F-150 and Ford Mustang models. The VDO A2C59519707Z is a practical OE replacement for drivers and technicians seeking a direct-match component for throttle control service.

Common Problems This Part Can Address

• Rough or unstable idle caused by throttle body wear
• Delayed or inconsistent throttle response
• Reduced fuel economy from improper air metering
• Check engine light related to throttle position or airflow faults
• Driveability issues on 2011-2014 Ford F-150 and Ford Mustang models

Installation Notes and Tips

Verify connector shape, terminal count, and intake port diameter before installation. Because mounting hardware and gasket or seal are not included, inspect the mating surfaces and replace related sealing components as needed during service. After installation, perform any required throttle relearn or idle relearn procedure specified by the vehicle manufacturer.

Quality Assurance

VDO builds this throttle body to original equipment specifications for consistent fit and function. The A2C59519707Z is manufactured as an OE-style replacement for technicians and DIY installers who need a factory-matched electronic throttle body for Ford F-150 and Ford Mustang service.