Vemo V10-70-0051 Ignition Control Module

VEMO Ignition Control Module for Audi and Volkswagen

The Vemo V10-70-0051 ignition control module is built for direct-fit service on select Audi and Volkswagen applications from 1997-2001. With a compact 70 mm length, 67 mm width, and 20 mm height, it is sized for OE-style replacement where precise electrical control and connector alignment matter.

VEMO is the Vemo product line used for replacement electrical and ignition components, and this module follows that approach with application-specific fitment for Audi A4, Audi A4 Quattro, Audi A8, Audi A8 Quattro, Volkswagen Beetle, and Volkswagen Passat models listed below.

Key Features

• Part number: V10-70-0051
• Ignition control module for select Audi and Volkswagen vehicles
• 9-pole electrical connection
• Compact housing dimensions: 70 mm length, 67 mm width, 20 mm height
• Lightweight design at 0.074 kg
• OE-style replacement for ignition system service

Detailed Description

The Vemo V10-70-0051 ignition control module is a replacement ignition component for vehicles that require accurate signal control within the ignition system. Its 9-pole layout and compact housing support proper electrical interface and packaging in the original mounting location. This part number is commonly searched for Audi A4 ignition control module replacement, Audi A8 ignition control module replacement, and Volkswagen Beetle ignition control module service. This part cross-references Bosch 15857 for the same application.

Vehicle Fitment

• Fits 1999-2001 Volkswagen Beetle, N/A
• Fits 1999-2000 Audi A4 Quattro, N/A; Grade: Aftermarket; EngineVIN: B
• Fits 1997-1999 Audi A4, N/A; Grade: Aftermarket; EngineVIN: B
• Fits 1997-1999 Audi A4 Quattro, N/A
• Fits 1997-1999 Audi A8, N/A
• Fits 1997-1999 Audi A8 Quattro, N/A
• Fits 1998-1999 Volkswagen Passat, N/A

Common Issues This Part May Address

• Ignition system no-start conditions related to module failure
• Intermittent spark or weak ignition output
• Engine misfire caused by inconsistent ignition control
• Rough running or stalling tied to ignition signal loss
• Diagnostic trouble codes associated with ignition control faults

Installation Notes and Tips

Verify connector count, mounting dimensions, and vehicle engine code before installation. Confirm the existing module matches the 9-pole configuration and compare the original part number against V10-70-0051 for proper application matching on Audi A4, Audi A8, and Volkswagen Passat models. Clean electrical terminals and inspect related ignition wiring before final assembly.

Quality Assurance

Vemo replacement electrical components are built for application-specific service on European vehicles, with dimensions and connector layout matched to the listed fitments for consistent installation and electrical compatibility.