Vemo V10-72-0991 Engine Crankshaft Position Sensor

Engine Crankshaft Position Sensor for Audi

The Vemo V10-72-0991 is an inductive engine crankshaft position sensor built for direct crankshaft signal monitoring in select Audi applications. It uses a 3-pin, 12-volt design with a 860-ohm resistance specification and a 575 mm lead length for OE-style replacement needs.

Compatible With Audi S4, Audi A6 Quattro, Audi Allroad Quattro, Audi A8 Quattro, Audi S6, and Audi S8 applications that use OE reference 077905381F. The VEMO line focuses on application-specific ignition and sensor components for European vehicles.

Key Features

• Engine crankshaft position sensor for crankshaft signal input
• Inductive sensor design
• 3-pole connector layout
• 12 V rated voltage
• 860 ohm resistance specification
• 575 mm overall lead length
• Compact sensor body: 44.3 mm height, 38 mm width
• Lightweight construction at 0.070 kg

Detailed Description

Vemo V10-72-0991 is an aftermarket crankshaft position sensor for Audi vehicles that rely on a 3-pin inductive sensor with OE reference 077905381F. It is listed for 2000-2006 Audi A6 Quattro, 2003-2005 Audi Allroad Quattro, 2000-2003 Audi A8 Quattro, 2002-2003 Audi S6, 2001-2003 Audi S8, and 2004-2009 Audi S4. This part cross-references Bosch 0261210190 for the same application.

As an engine crankshaft position sensor, it provides the signal used by the engine management system to track crankshaft position and engine speed. That makes it a direct replacement choice for Audi S4 crankshaft position sensor, Audi A6 Quattro crankshaft sensor, and other listed V10-72-0991 fitments where the OE connector and sensor specifications match.

Common Issues This Part Can Address

• Crankshaft position sensor fault codes
• Intermittent no-start or hard-start conditions
• Rough running caused by missing crankshaft signal
• Stalling related to crankshaft signal loss
• Engine speed or timing signal irregularities

Installation Notes and Tips

Verify connector style, lead length, and OE number before installation. Confirm the vehicle uses the listed 3-pin configuration and compare the existing sensor against the Vemo V10-72-0991 dimensions and electrical specifications. Clean the mounting area and inspect the harness connector for corrosion or damaged terminals before connecting the new sensor.

Quality Assurance

VEMO supplies application-specific ignition and sensor components for European vehicle service needs. This part is specified with defined electrical and dimensional data to support accurate OE-style replacement selection.