Vemo V10-72-1118 Engine Camshaft Position Sensor

VEMO Camshaft Position Sensor for OE Fitment

The Vemo V10-72-1118 engine camshaft position sensor is built for direct replacement on select Volkswagen and Audi applications with a 3-pin Hall sensor design. It uses a black housing, 12-volt rating, and seal ring for a clean OE-style fit on vehicles such as the Volkswagen Jetta, Golf, Beetle, and Audi A4.

VEMO is the brand line used for OE-style replacement parts, and this camshaft position sensor follows that approach with application-specific dimensions and connector layout. The V10-72-1118 is a practical choice when diagnosing camshaft signal faults on 2.5L-equipped Volkswagen and Audi models.

Key Features

• Engine camshaft position sensor with Hall sensor technology
• 3 connectors / 3 poles for OE-style electrical connection
• Black housing with integrated seal ring
• 12 V rated electrical design
• Dimensions: 80 mm length, 55 mm width, 55 mm height, 24 mm fitting depth
• Direct replacement reference: VEMO V10-72-1118

Detailed Description

This camshaft position sensor monitors camshaft position and sends the signal needed for accurate engine timing and fuel control. It is listed for a wide range of Volkswagen and Audi vehicles, including Fits 2005-2014 Volkswagen Jetta, N/A; Fits 2010-2014 Volkswagen Golf, N/A; Fits 2006-2010 Volkswagen Beetle, N/A; Fits 2012-2014 Volkswagen Passat, N/A; and Fits 2005-2008 Audi A4, N/A. The same OE reference also applies to Fits 2008 Audi A3, N/A and Fits 2008-2009 Audi TT, N/A.

This part cross-references URO 07K907601A for the same application. The VEMO V10-72-1118 is also referenced against OE number 07K 907 601 A, making it a strong match for buyers searching for a Volkswagen Jetta camshaft position sensor, Audi A4 camshaft sensor, or Volkswagen Golf Hall sensor replacement.

Common Issues This Sensor May Address

• Camshaft position sensor fault codes
• Hard starting or extended crank conditions
• Rough idle or inconsistent engine operation
• Intermittent stalling related to camshaft signal loss
• Check engine light triggered by camshaft sensor errors

Installation Notes and Tips

Verify the OE number, connector style, and engine application before ordering. This sensor uses a 3-pin connector and includes a seal ring, so inspect the mounting area for debris or oil contamination before installation. Confirm the sensor depth and housing dimensions against the original part to ensure proper seating on the engine.

For best results, clear stored fault codes after installation and recheck live data if the vehicle previously showed camshaft correlation or signal issues. Always match the part to the exact vehicle configuration listed in the fitment data.

Quality Assurance

VEMO parts are positioned as OE-style replacement components with application-specific fitment and construction details. The V10-72-1118 is built to match the listed Volkswagen and Audi applications and OE reference 07K907601A.