Vemo V10-72-1149 Engine Camshaft Position Sensor

Engine Camshaft Position Sensor for Audi

The Vemo V10-72-1149 is an engine camshaft position sensor built with a Hall sensor design and a 3-pin rectangular connector. It uses a 12V electrical rating and is supplied without cable, making it a direct replacement option for select Audi applications that require accurate camshaft signal input.

Compatible With Audi A6 Quattro, Audi Cabriolet, Audi A4, Audi A4 Quattro, Audi A6, Audi 90, Audi 90 Quattro, Audi 100, and Audi 100 Quattro across 1992-1998 model years. The VEMO line focuses on application-specific ignition and sensor components, and this part number V10-72-1149 follows that approach for OE-style fitment.

Key Features

• Engine camshaft position sensor for ignition and engine management systems
• Hall sensor construction for camshaft signal detection
• 3-pin / 3-pole rectangular connector
• 12V rated electrical specification
• Dimensions: 82 mm length, 95 mm width, 22 mm height
• Supplied without cable
• Part number: V10-72-1149

Detailed Description

This Vemo camshaft position sensor monitors camshaft position so the engine control system can synchronize fuel and ignition timing. It is a fitment-based replacement for select Audi models, including Audi A4, Audi A6, Audi A6 Quattro, Audi Cabriolet, Audi 90, Audi 90 Quattro, Audi 100, and Audi 100 Quattro. If you are searching for an Audi camshaft position sensor V10-72-1149 or a 3-pin Hall sensor replacement for older Audi engines, this part matches the listed applications.

This part cross-references Standard Ignition PC150 for the same application.

Common Issues It May Address

• Camshaft signal loss or intermittent sensor output
• Hard starting or extended crank conditions tied to camshaft timing input
• Rough idle caused by incorrect engine synchronization data
• Check engine light concerns related to camshaft position sensor faults
• Driveability issues on Audi A4, Audi A6, and related applications

Installation Notes and Tips

Verify connector shape, pin count, and sensor mounting dimensions before installation. This Vemo V10-72-1149 uses a rectangular 3-pin connector and is listed without cable, so confirm the vehicle harness and routing match the original setup. Always compare the old sensor to the replacement part and clear diagnostic trouble codes after installation if required by the vehicle.

Quality Assurance

VEMO supplies application-specific ignition and sensor components for European vehicle service needs. This camshaft position sensor is built to match the listed Audi fitments and electrical specifications for direct replacement use.