Vemo V10-76-0060 Oxygen Sensor

VEMO Oxygen Sensor for Volkswagen and Audi

The Vemo V10-76-0060 oxygen sensor is a 4-wire emission control sensor built for select Volkswagen and Audi applications. It uses a ZR-PLANAR design with an M18 x 1.5 thread, D-shape connector, and pre-greased threads for service replacement on the listed rear, downstream, center, and front positions.

VEMO VEMO focuses on OE-style replacement parts for European vehicles, and this oxygen sensor follows that approach with application-specific fitment for Volkswagen Beetle, Golf, Jetta, Golf City, Jetta City, R32, and Audi TT Quattro models.

Key Features

• Part number: V10-76-0060
• 4-conductor, 4-pole oxygen sensor design
• ZR-PLANAR sensor version for listed applications
• M18 x 1.5 thread size with thread pre-greased
• D-shape connector for direct replacement-style service
• Cable length: 225 mm; overall length: 390 mm
• Fits select Volkswagen and Audi emission control applications

Detailed Description

This Vemo oxygen sensor is specified for vehicles that use a 4-wire planar lambda sensor in the exhaust stream. The sensor’s 225 mm cable length, 34 mm width, 22 mm height, and 390 mm overall length support the listed fitments, while the pre-greased thread helps simplify removal and installation on the M18 x 1.5 mounting point. If you are replacing a worn sensor on a Volkswagen Beetle, Golf, Jetta, Golf City, Jetta City, R32, or Audi TT Quattro, V10-76-0060 provides the correct connector shape and sensor configuration for the applications shown.

This part cross-references Walker Products 250-24263 and Delphi ES20168 for the same application.

What It Is Used For

• Replacing a failed upstream or downstream oxygen sensor on listed Volkswagen and Audi models
• Restoring air-fuel ratio feedback to the engine management system
• Addressing oxygen sensor fault codes related to heater or signal performance
• Correcting drivability issues tied to inaccurate exhaust oxygen readings
• Supporting emissions system monitoring on the specified vehicles

Installation Notes and Tips

Verify connector style, wire count, and sensor position before installation. Confirm the vehicle uses the listed M18 x 1.5 thread and planar 4-wire configuration, and compare the original sensor length to the 225 mm cable and 390 mm overall length. Use the fitment notes to match the correct position, including rear, downstream, center, front, or rear right where specified. For Volkswagen Beetle, Golf, Jetta, Golf City, Jetta City, R32, and Audi TT Quattro applications, confirm the exact engine and exhaust layout before ordering.

Quality Assurance

VEMO VEMO supplies OE-style replacement emission control components for European vehicle applications. This oxygen sensor is built to match the listed fitment and connector specifications for direct replacement service on the confirmed vehicles.