Vemo V10-76-0151 Oxygen Sensor - Downstream or Rear

VEMO Oxygen Sensor for VW and Audi

The Vemo V10-76-0151 is a post-catalyst oxygen sensor built for downstream exhaust monitoring on select Audi and Volkswagen models. It uses a 4-wire, 4-circuit design with a D-shape connector and a thread pre-greased sensor body for OE-style replacement service.

Compatible With Audi A3, Audi S3, Audi TT Quattro, Volkswagen Golf, Golf Alltrack, Golf R, Golf SportWagen, and GTI applications listed below, this oxygen sensor is specified for rear or downstream placement. The VEMO line focuses on direct-fit emission control components, and this part number V10-76-0151 follows that approach with application-specific connector and length details.

Key Features

• Part number: V10-76-0151
• Post-catalyst oxygen sensor for rear/downstream exhaust positions
• 4 conductor, 4-circuit, 4-pole design
• D-shape connector for OE-style electrical connection
• Sensor length: 780 mm
• Thread pre-greased for service-ready installation
• Compact sensor body dimensions: 25 mm height and 25 mm width

Detailed Description

This Vemo oxygen sensor monitors exhaust gas content after the catalytic converter, helping the engine management system evaluate catalyst efficiency and maintain proper emissions control. It is listed for 2015-2017 Volkswagen Golf, Golf Alltrack, Golf R, Golf SportWagen, and GTI rear or downstream positions, plus 2015-2017 Audi S3 and 2017 Audi A3 and TT Quattro rear/downstream applications. The V10-76-0151 also cross-references OE-style part number 06K 906 262 AC for the same application.

Use this sensor when replacing a worn or faulted downstream oxygen sensor on supported Audi A3, Audi S3, Volkswagen Golf GTI, and related MQB-platform vehicles. The 780 mm lead length and 4-wire configuration support direct replacement where the original connector and routing match the listed vehicle fitment.

Common Issues This Part May Address

• Check engine light related to downstream oxygen sensor performance
• Fault codes tied to catalyst efficiency monitoring
• Incorrect exhaust oxygen readings after the catalytic converter
• Rough emissions test results caused by a failing rear sensor
• Connector or wiring mismatch when replacing the original OE sensor

Installation Notes and Tips

Confirm the vehicle’s OE number and sensor position before installation. This part is listed for rear and downstream locations only, so match the original sensor placement on the exhaust system. The thread is pre-greased, but the sensor should still be installed carefully to avoid cross-threading and to ensure the connector locks fully into place.

Verify fitment for your exact model year and engine configuration before ordering. This part is listed for 2015-2017 Volkswagen Golf, Golf Alltrack, Golf R, Golf SportWagen, and GTI, plus 2015-2017 Audi S3 and 2017 Audi A3 and TT Quattro applications.

Quality Assurance

VEMO supplies emission control components with OE-style specifications and application-matched connector and sensor details. Part number V10-76-0151 is built to align with the listed OE reference and vehicle fitment data for supported Audi and Volkswagen applications.