Vemo V10-92-1486 ABS Wheel Speed Sensor Tone Ring - Rear, Rear Left or Rear Right

ABS Wheel Speed Sensor Tone Ring for Rear Applications

The Vemo V10-92-1486 ABS wheel speed sensor tone ring is a rear-mounted ABS ring for select Audi and Volkswagen models. It is built for wheel bearings and wheel hub applications where the ABS system reads tooth count and ring geometry to monitor wheel speed.

Use this VEMO tone ring when servicing rear ABS components on vehicles such as the Audi TT and Volkswagen Golf, Jetta, Beetle, Cabrio, and Passat. The V10-92-1486 part number is listed for OE-style replacement needs where the original ring specification must match the hub assembly.

Key Features

• ABS wheel speed sensor tone ring for rear wheel applications
• 43 teeth for ABS signal generation
• Inner diameter: 61 mm
• Outer diameter: 79.5 mm
• Width: 79 mm; length: 79 mm; height: 21 mm
• For wheel bearings and wheel hub use
• Vemo part number: V10-92-1486

Detailed Description

VEMO V10-92-1486 is an ABS ring designed to work with the rear wheel bearing or wheel hub assembly and provide the toothed reference pattern used by the ABS sensor. Its 43-tooth design and measured dimensions help maintain the correct relationship between the sensor and the rotating ring, which is important for accurate wheel speed input. This part is listed for rear right, rear left, and rear positions depending on the vehicle application.

Fitment includes 2000-2006 Audi TT and Audi TT Quattro, 2000-2006 Volkswagen Beetle and Golf, 2000-2005 Volkswagen Jetta, 2002 Volkswagen Cabrio, 1998-2001 Volkswagen Cabrio, 1998-1999 Volkswagen Beetle, 1998 Volkswagen Golf, and 1990-1997 Volkswagen Passat. The V10-92-1486 part number is also cross-referenced to OE-style numbers 1J0 614 149 and 191 614 149 for the same application.

What It Helps Address

• ABS warning light caused by a damaged or missing tone ring
• Erratic wheel speed signal from worn or corroded ring teeth
• ABS sensor reading issues after hub or bearing service
• Loss of proper ABS input at the rear axle
• Fitment concerns when replacing an OE-style rear ring on Audi TT or Volkswagen models

Installation Notes and Tips

Confirm the rear position and compare the ring dimensions, tooth count, and OE reference before installation. This part is specified for wheel bearings and wheel hub applications, so inspect the hub surface and ABS sensor gap during service. Verify the vehicle’s original part number and rear axle configuration on the Audi TT, Volkswagen Golf, Jetta, Beetle, Cabrio, or Passat before ordering.

Quality Assurance

VEMO supplies OE-style replacement components for brake and ABS systems, and this tone ring is cataloged to match the listed application references and dimensions. Part number V10-92-1486 is provided for direct identification during parts lookup and service verification.