Vemo V26-72-0092 ABS Wheel Speed Sensor - Front Left

ABS Wheel Speed Sensor for Acura TL

Restore accurate wheel speed input with this Vemo ABS wheel speed sensor, part number V26-72-0092. It is built for vehicles with ABS and is listed for the front left position on 2004-2008 Acura TL models.

Key Features

• ABS wheel speed sensor for front left installation
• Rated voltage: 12 V
• Dimensions: 90 mm height, 250 mm length, 100 mm width
• Lightweight design at 0.128 kg
• Packaged in foil material for protection during handling
• Direct fit application for 2004-2008 Acura TL with ABS

Product Details

Vemo V26-72-0092 is an ABS wheel speed sensor engineered for vehicles equipped with ABS, with fitment listed for the 2004-2008 Acura TL front left position. This sensor helps provide the wheel speed signal used by the braking and drive dynamics system, supporting proper ABS operation and related stability functions. If you are searching for a front left Acura TL ABS wheel speed sensor or a V26-72-0092 replacement for 2004-2008 Acura TL models, this part matches the listed application.

This part cross-references Standard Ignition ALS1004 for the same application.

Common Issues It Can Help Address

• ABS warning light caused by a failed front left wheel speed sensor
• Erratic or missing wheel speed signal at the braking system
• ABS system faults on 2004-2008 Acura TL models
• Loss of proper wheel speed input for ABS-related control functions
• Diagnostic trouble codes tied to the front left sensor circuit

Installation Notes and Tips

Confirm the vehicle is a 2004-2008 Acura TL with ABS and verify the front left location before ordering. Compare the connector, lead length, and mounting points on the original sensor to the replacement part number V26-72-0092. After installation, clear any stored ABS codes and road test the vehicle to confirm the warning lamp remains off.

Quality Assurance

Vemo V26-72-0092 is cataloged as an OE-style ABS wheel speed sensor for the listed Acura TL application. The part number and fitment data should be matched to the vehicle identification and existing sensor configuration before installation.