Vemo V49-72-0008 Engine Crankshaft Position Sensor

Engine Crankshaft Position Sensor for Land Rover

The Vemo V49-72-0008 engine crankshaft position sensor is an inductive sensor built for precise crankshaft signal monitoring in select Land Rover applications. It is a 12-volt, 2-pin sensor with a compact white housing and no cable, making it a direct-fit replacement for vehicles that require this connector style.

Compatible With 1996-1999 Land Rover Discovery, 1997-1998 Land Rover Range Rover, and 1997 Land Rover Defender 90. The VEMO line focuses on OE-style replacement components for ignition and engine management systems, with attention to fit, connector layout, and electrical specifications.

Key Features

• Part number: V49-72-0008
• Engine crankshaft position sensor for ignition and engine timing input
• Inductive sensor design
• 12 V rated voltage
• 2 connectors / 2 poles
• White housing
• Dimensions: 68 mm length, 34 mm width, 35 mm height
• Supplied without cable
• Resistance: 1300 Ohm

Detailed Description

The Vemo V49-72-0008 is an engine crankshaft position sensor used to monitor crankshaft position and rotational speed for the engine control system. Accurate signal input from this sensor supports ignition timing and engine synchronization in Land Rover Discovery, Range Rover, and Defender 90 applications listed above. This part cross-references Standard Ignition PC714 for the same application.

As part of the VEMO product line, this sensor is specified with a 2-pin connector, inductive sensing element, and compact housing dimensions for applications that require the listed electrical and physical configuration. The part number V49-72-0008 is the key identifier for matching the correct replacement to the original sensor setup.

What It Helps Address

• Crankshaft signal loss or intermittent engine speed input
• Hard starting caused by incorrect crank position data
• Stalling related to faulty engine timing signals
• Misfire or rough running from inconsistent sensor output
• Check engine light conditions tied to crankshaft position sensor faults

Installation Notes and Tips

Verify connector style, mounting location, and sensor dimensions before installation. This sensor uses a 2-pin connection and is supplied without cable, so confirm the vehicle harness and routing match the original setup. Clean the mounting area and inspect the connector terminals for corrosion or damage before fitting the replacement.

Quality Assurance

VEMO replacement sensors are built to match the listed electrical and dimensional specifications for the application. Confirm fitment by year, make, model, and connector type before ordering. Part number V49-72-0008 should be matched against the original sensor reference for accurate application selection.