Vemo V95-70-0011 Distributor Rotor

Distributor Rotor for Volvo Ignition Service

The Vemo V95-70-0011 distributor rotor is an OE-style ignition component for select Volvo applications. It is built to match the listed dimensions and 1000 ohm resistance specification for Bosch-restricted systems, helping maintain consistent distributor operation in compatible Volvo 850, C70, S70, and V70 models.

Key Features

• Distributor rotor for ignition and distributor service
• Part number: V95-70-0011
• Resistance: 1000 ohm
• Dimensions: 42 mm height, 53 mm length, 51 mm width
• Manufacturer restriction: BOSCH
• Fits select 1995-1998 Volvo applications
• Cross-reference part number: 1 367 783

Product Details

VEMO V95-70-0011 is a distributor rotor for ignition systems that use a Bosch-restricted design. The rotor’s measured dimensions and electrical resistance are listed to support accurate replacement selection, especially when matching OE No. 1367783. This part cross-references Bosch 1 367 783 and D715P for the same application. For Volvo 850, Volvo C70, Volvo S70, and Volvo V70 service, the V95-70-0011 provides a direct-fit replacement path when the original rotor matches the specified OE reference and Bosch application.

Vehicle Fitment

• Fits 1998 Volvo C70, N/A. Notes: Grade: Aftermarket; With OE No. 1367783; VEMO.
• Fits 1998 Volvo S70, N/A. Notes: Grade: Aftermarket; With OE No. 1367783; VEMO.
• Fits 1998 Volvo V70, N/A. Notes: Grade: Aftermarket; With OE No. 1367783; VEMO.
• Fits 1995-1997 Volvo 850, N/A. Notes: Grade: Aftermarket; With OE No. 1367783; VEMO.

Common Replacement Uses

• Restores distributor rotor contact transfer in worn ignition systems
• Addresses misfire symptoms caused by rotor wear or carbon tracking
• Replaces a cracked, burned, or corroded rotor in Bosch-based Volvo ignition setups
• Supports repair of hard-start or intermittent ignition performance concerns
• Helps correct ignition timing irregularities caused by rotor deterioration

Installation Notes

Verify the OE reference, Bosch restriction, and rotor dimensions before installation. Compare the old rotor’s height, length, width, and resistance to V95-70-0011 to confirm application match. Inspect the distributor cap, terminals, and ignition leads during service so the replacement rotor is installed into a clean, serviceable ignition system.

Quality Assurance

VEMO supplies this distributor rotor as an aftermarket replacement built around the listed OE application data and dimensional specifications. Use the OE number 1367783 and the Bosch restriction to confirm the correct part before installation.