Vemo V95-76-0014 Oxygen Sensor - Downstream or Rear

Vemo V95-76-0014 Oxygen Sensor for Volvo

The Vemo V95-76-0014 is a rear oxygen sensor for select Volvo S60 and Volvo V70 applications. Built with a 4-conductor design and an 810 mm lead length, it supports accurate exhaust monitoring on listed downstream and rear positions.

Key Features

• Part number: V95-76-0014
• Oxygen sensor for emission control systems
• 4-conductor design
• 810 mm cable length; 710 mm cable length listed
• M18x1.5 thread size with pre-greased threads
• Compact sensor body: 25 mm height and 25 mm width
• Direct-fit style for listed Volvo S60 and Volvo V70 rear/downstream locations

Product Details

VEMO V95-76-0014 is part of VEMO’s emission control sensor line, focused on replacement components for exhaust feedback systems. This oxygen sensor uses a 4-wire configuration and an M18x1.5 thread, with pre-greased threads to support installation into the exhaust stream. The listed cable length and sensor dimensions make it a fitment-specific replacement for the rear or downstream position on select Volvo S60 and Volvo V70 models. This part number, V95-76-0014, also cross-references Delphi ES20212 for the same application.

Compatible With Volvo S60 and Volvo V70 applications listed below, this sensor is referenced for 2001-2008 Volvo S60 rear and downstream positions, and 2001-2007 Volvo V70 rear and downstream positions, with chassis and OE-number notes as specified in the fitment data. If you are replacing a rear oxygen sensor on a Volvo S60 or Volvo V70, V95-76-0014 is the cataloged match for the listed configurations.

What It Helps Address

• Check engine light related to oxygen sensor faults
• Incorrect exhaust oxygen readings
• Fuel trim issues caused by a failing downstream sensor
• Emission test failures tied to sensor performance
• Slow or inaccurate sensor response in the rear exhaust position

Installation Notes and Tips

Verify the vehicle’s chassis breakpoints, OE number, and sensor position before ordering. This sensor is listed for rear and downstream locations only, so confirm the original connector count, cable routing, and thread specification match the existing part. Use care when removing the old sensor from the exhaust to avoid damaging the bung threads.

Quality Assurance

VEMO supplies emission control components for replacement use, and this oxygen sensor is cataloged with OE-reference fitment details for the listed Volvo applications. The pre-greased thread specification and exact connector count support a precise replacement selection for the correct vehicle configuration.