Victor Reinz 15-10683-01 Exhaust Manifold Gasket Set

Exhaust Manifold Gasket Set for OE Fitment

Victor Reinz 15-10683-01 is an exhaust manifold gasket set built for high-heat sealing at the manifold-to-cylinder head interface. It is made with steel construction and a 0.040-inch thickness to support a consistent seal on a wide range of Asian applications, including Kia Magentis, Kia Optima, Hyundai Sonata, and Hyundai Santa Fe.

Victor Reinz has a long OE supply history, and this gasket set follows OE specifications for vehicles ranging from recent engine designs back to earlier performance-era applications. Part number 15-10683-01 is a direct-fit sealing solution for exhaust manifold service where heat cycling and sealing integrity matter.

Key Features

• Steel exhaust manifold gasket construction
• 0.040-inch thickness for controlled sealing
• One-piece configuration
• 7 bolt hole design
• Color may vary by production run
• OE-spec sealing approach for Kia and Hyundai applications

Vehicle Fitment

• Fits 2001-2010 Kia Magentis, N/A
• Fits 2001-2010 Kia Optima, N/A
• Fits 2007-2010 Kia Rondo, N/A
• Fits 2005-2010 Kia Sportage, N/A
• Fits 2001-2009 Hyundai Santa Fe, N/A
• Fits 2005-2009 Hyundai Tucson, N/A
• Fits 2003-2008 Hyundai Tiburon, N/A
• Fits 1999-2005 Hyundai Sonata, N/A

Detailed Description

This Victor Reinz exhaust manifold gasket set is engineered for vehicles that see repeated thermal expansion and contraction at the exhaust manifold. The steel material and 0.040-inch thickness help maintain a stable seal under exhaust heat, while the one-piece layout supports straightforward alignment during service. If you are replacing a leaking exhaust manifold gasket on a Hyundai Sonata, Hyundai Santa Fe, Kia Optima, or Kia Magentis, part number 15-10683-01 matches the OE-style application profile used across these platforms.

This part cross-references MAHLE MS19308 for the same application.

What It Helps Address

• Exhaust leaks at the manifold-to-head sealing surface
• Ticking or puffing noises from a leaking manifold gasket
• Loss of exhaust sealing after heat cycling
• Service replacement for damaged or warped original gasket material
• Fitment-specific repair on Kia and Hyundai exhaust systems

Installation Notes and Tips

Inspect the exhaust manifold and cylinder head sealing surfaces before installation. Remove carbon buildup, corrosion, and old gasket material so the new gasket can seat evenly. Confirm bolt hole alignment and torque fasteners in the manufacturer-specified sequence for the vehicle being serviced. For best results, verify the manifold and fasteners are in serviceable condition before installing 15-10683-01.

Quality Assurance

Victor Reinz supplies exhaust manifold gaskets to original equipment vehicle manufacturers and builds this part to OE specifications for the listed Kia and Hyundai applications. The design reflects the sealing demands of high-temperature exhaust service and the fitment requirements of the vehicles shown above.