Victor Reinz 71-13779-00 EGR Valve Gasket

OE-Style EGR Valve Gasket for Ford Applications

Victor Reinz 71-13779-00 is an exhaust gas recirculation (EGR) valve gasket built with steel construction and OE-quality sealing engineering. It is made for service work on Ford, Lincoln, and Mercury vehicles where a precise seal between the EGR valve and mating surface is required.

With a compact 2.5000-inch length, 1.2500-inch width, and 0.0200-inch thickness, this gasket is sized for specific EGR valve sealing points and uses a single-port, 2-bolt-hole layout. Victor Reinz 71-13779-00 is a direct-fit sealing solution for many Ford E-150, E-250, Explorer, F-150, Mustang, and related applications.

Key Features

• Steel gasket material for durable sealing performance
• OE-quality design from Victor Reinz, an original equipment supplier
• 2-bolt-hole, 1-port configuration
• Dimensions: 2.5000 in. length, 1.2500 in. width, 0.0200 in. thickness
• Used in EGR valve sealing locations on select Ford, Lincoln, and Mercury vehicles
• Part number 71-13779-00 for accurate ordering and lookup

Detailed Description

Victor Reinz 71-13779-00 is an EGR valve gasket engineered for sealing the joint between the EGR valve and the manifold or related mounting surface. The steel construction supports a stable seal in emission control service, where heat and exhaust flow can challenge lesser materials. As an OE supplier, Victor Reinz focuses on gasket fit and sealing consistency for foreign and domestic vehicle repair.

This gasket cross-references Dayco 71176 and MAHLE G31851 for the same application. It is a practical replacement choice for technicians servicing Ford E-150, Ford E-250, Ford Explorer, Ford F-150, Ford Mustang, Lincoln Town Car, and Mercury Grand Marquis EGR valve repairs. The part number 71-13779-00 also helps confirm the correct sealing component when matching the original gasket profile.

Common Repair Uses

• Exhaust leak at the EGR valve mounting surface
• Rough idle or drivability issues related to EGR sealing loss
• Check engine light concerns tied to EGR flow or sealing faults
• Visible soot or carbon buildup around the EGR valve flange
• Replacement during EGR valve service on Ford and Lincoln/Mercury platforms

Installation Notes and Tips

Inspect the EGR valve and mating surfaces before installation. Remove carbon buildup, check for warpage, and verify that the bolt holes and port alignment match the original gasket profile. For best sealing results, install on clean, flat surfaces and torque fasteners to the vehicle manufacturer’s specification.

Confirm vehicle application by year, make, model, and EGR valve position before ordering. This gasket is listed for multiple Ford, Lincoln, and Mercury applications, including 2005-2014 Ford E-150 and E-250, 2003-2011 Ford Crown Victoria, 2003-2011 Lincoln Town Car, 2003-2011 Mercury Grand Marquis, and select Ford Explorer, F-150, and Mustang configurations.

Quality Assurance

Victor Reinz is recognized as an original equipment supplier, and this gasket reflects OE-quality sealing technology and engineering for emission control service. The 71-13779-00 part number is supported by broad coverage across multiple Ford, Lincoln, and Mercury applications, helping ensure the correct replacement for the intended EGR valve seal.