Victor Reinz 71-13783-00 Fuel Injection Throttle Body Mounting Gasket

OE-Style Throttle Body Sealing

Victor Reinz 71-13783-00 is a fuel injection throttle body mounting gasket made from molded rubber for a precise seal at the throttle body interface. It is built for Ford, Lincoln, Mazda, Buick, Chevrolet, Pontiac, Saturn, and Mercury applications where a reliable intake seal is needed.

With OE-focused gasket engineering and broad vehicle coverage, this gasket supports clean reassembly on service jobs involving the throttle body, intake tract, or related air and fuel delivery repairs. Compatible With 2011-2016 Ford Explorer, 2011-2016 Ford Mustang, and other listed applications.

Key Features

• Molded rubber construction for consistent sealing performance
• Fuel injection throttle body mounting gasket for intake system service
• OE-quality gasket technology from Victor Reinz
• Broad coverage across Ford, Lincoln, Mazda, and GM platforms
• Part number 71-13783-00 for accurate ordering and lookup

Detailed Product Overview

Victor Reinz 71-13783-00 is engineered as a direct sealing component for throttle body mounting points on a wide range of vehicles from 2006-2018. It is a practical choice for service on Ford F-150, Ford Edge, Ford Taurus, Lincoln MKZ, Mazda CX-9, Chevrolet Impala, and related models where the throttle body gasket must maintain a stable seal between mating surfaces. This part cross-references FEL-PRO 61466 for the same application.

As an OE supplier brand, Victor Reinz focuses on gasket fit, material consistency, and dependable sealing geometry. The molded rubber design helps maintain contact at the throttle body flange and supports proper air management in the intake system.

Common Repair Uses

• Throttle body air leaks after service or removal
• Rough idle caused by intake sealing loss
• Unmetered air entering the intake tract
• Vacuum-related drivability complaints at the throttle body mount
• Reassembly after throttle body cleaning or replacement

Installation Notes

Clean both mating surfaces before installation and inspect the throttle body flange for damage, warping, or residue. Align the gasket carefully during reassembly so the molded rubber seats evenly. Verify fastener torque with the vehicle service specification and confirm there are no intake leaks after installation.

Quality Assurance

Victor Reinz supplies OE-level gasket technology and engineering, with broad coverage for foreign and domestic vehicles. Part number 71-13783-00 is built to support accurate fitment and dependable sealing on the listed applications.