Victor Reinz 71-52361-00 Engine Valve Cover Gasket Set

Valve Cover Gasket Set for Honda Prelude and Accord

Victor Reinz 71-52361-00 is an engine valve cover gasket set built with molded rubber for reliable oil sealing at the valve cover. It is designed to handle the heat and stress found near exhaust manifolds, cylinder head exhaust crossovers, and EGR systems while helping maintain a clean engine bay.

Compatible with 1983-1990 Honda Prelude and 1984-1989 Honda Accord applications listed below, this Victor Reinz valve cover gasket set is a direct-fit sealing solution for common oil leak repairs. The 71-52361-00 part number is also referenced in aftermarket interchange listings for the same application.

Key Features

• Molded rubber construction for consistent sealing performance
• Two-piece configuration for listed Honda applications
• Regular grade replacement gasket set
• Designed to seal oil and oil spray at the valve cover
• Built to withstand elevated engine bay temperatures
• Compression-limiter design used where applicable to reduce over-torquing and splitting

Detailed Description

Victor Reinz 71-52361-00 focuses on the sealing demands of older Honda engines where valve cover leaks can lead to oil residue, smoke, and recurring maintenance issues. The molded rubber material helps maintain contact pressure across the cover surface, while the gasket design is intended to resist heat exposure from nearby exhaust components. This makes it a practical choice for Honda Prelude and Honda Accord owners looking for a dependable valve cover sealing repair.

Fits 1983-1990 Honda Prelude, N/A. Fits 1984-1985 Honda Accord, N/A. Fits 1986-1989 Honda Accord, N/A. The 71-52361-00 part number should be matched to the exact engine application and notes shown for each vehicle.

This part cross-references MAHLE VS50023 for the same application.

Common Problems This Part Helps Address

• Oil seepage around the valve cover perimeter
• Oil spots on the driveway or garage floor
• Burning oil odor from leaks onto hot engine components
• Visible oil residue on the cylinder head or engine exterior
• Repeated sealing issues from aged or hardened gasket material

Installation Notes and Tips

Clean the valve cover and cylinder head sealing surfaces thoroughly before installation. Inspect the cover for warpage, cracks, or damaged sealing grooves, and replace worn grommets if your application requires them; some listed Honda Prelude and Accord fitments note that valve cover grommets are not included. Follow the manufacturer torque sequence and tighten fasteners evenly to avoid distorting the gasket.

Quality Assurance

Victor Reinz is known for engine sealing components engineered for demanding temperature and oil-control conditions. The 71-52361-00 valve cover gasket set is built to support dependable sealing performance in the listed Honda Prelude and Honda Accord applications.