WAI DST35435 Distributor

Ignition Distributor for Mazda and Ford

The WAI DST35435 ignition distributor is a 100% new, complete unit built for direct replacement on select 1993-1994 Mazda 626, Mazda MX-6, and Ford Probe applications. It is engineered to meet or exceed OE form, fit, and function, with a Hall Effect design for consistent ignition signal delivery.

Built with an aluminum housing, melonized steel gear, and a new cap and rotor, this distributor is ready to install out of the box. The DST35435 is tested for long-lasting performance and is backed by WAI’s limited lifetime warranty.

• 100% new distributor assembly, ready to install
• Hall Effect distributor design
• Aluminum housing for OE-style fitment
• Melonized steel gear with 13 teeth
• Ignition coil included
• Distributor cap included with screw attachment method
• Ignition rotor included
• Tested to OE specifications for form, fit, and function

Detailed Product Overview

WAI DST35435 is a direct-fit ignition distributor for vehicles using the FS01 identifier, including 1994 Mazda 626, 1994 Mazda MX-6, 1993 Ford Probe, and 1993 Mazda 626 and MX-6. This part cross-references Ford F32Z 12127-A and FS01-18-200A for the same application. If you are replacing a worn distributor on a Mazda 626 or Mazda MX-6, or servicing a Ford Probe ignition system, this unit provides the core components needed for a complete replacement.

Common Issues This Part May Address

• Hard starting caused by distributor wear
• Intermittent misfire or rough idle
• No-start condition related to ignition signal loss
• Weak or inconsistent spark delivery
• Cap, rotor, or internal distributor component failure

Installation Notes and Tips

Verify the vehicle’s ID number and distributor configuration before ordering, especially on 1994 Mazda 626, Mazda MX-6, and Ford Probe models with FS01 identification. Confirm gear tooth count, connector style, and mounting layout against the original unit before installation. For best results, inspect related ignition components and set base timing according to factory service procedures after installation.

Quality Assurance

WAI manufactures this distributor as a 100% new assembly using new components throughout. Each unit is tested to meet OE specifications for fit and function, and the part is supported by a limited lifetime warranty.