Walker 16741 Catalytic Converter - Rear

Walker EPA Direct-Fit Catalytic Converter

Walker EPA Part Number 16741 is a direct-fit catalytic converter built for rear exhaust placement on select 2012-2014 Honda CR-V models. It is engineered for OBDII-era vehicles and follows EPA compliance requirements for federal-emissions applications.

The Walker EPA line focuses on direct-fit replacement converters for import and domestic vehicles, with application-specific fitment and emissions-focused construction. Part number 16741 is a specific-fit unit with a stainless steel body, ceramic substrate, and welded flange connections for the inlet and outlet.

Key Features

• Direct-fit catalytic converter for rear position
• Fits 2012-2014 Honda CR-V, rear
• EPA-compliant design for federal-emissions applications
• Stainless steel body with ceramic substrate
• 2-bolt welded flange inlet and 3-bolt welded flange outlet
• Round 4-inch body profile with 27-inch overall length
• Pre-catalyst oxygen sensor location
• Walker Part Number 16741

Detailed Description

Walker 16741 is a rear catalytic converter designed for direct replacement on 2012-2014 Honda CR-V models. It uses a stainless steel housing and ceramic substrate to match the application-specific exhaust layout, with a 2-bolt welded flange inlet and 3-bolt welded flange outlet for a direct-fit installation path. This unit is listed for federal-emissions use and is not CARB certified.

For shoppers searching for a 2012-2014 Honda CR-V rear catalytic converter, Walker 16741 provides the correct fitment profile for the listed vehicles. This part cross-references AP Exhaust 642832 for the same application.

What It Helps Address

• Failed catalytic converter efficiency codes
• Exhaust restriction from a worn rear converter
• Emissions test failure on listed federal-emissions vehicles
• Exhaust leaks at flange-connected converter joints
• Replacement needs for a damaged Honda CR-V rear converter

Installation Notes and Tips

Confirm the vehicle is a 2012-2014 Honda CR-V with the listed rear converter configuration before ordering. An exhaust gasket is recommended during installation. Verify the inlet and outlet flange styles, and check the oxygen sensor location before removal of the original converter.

Quality Assurance

Walker EPA catalytic converters are built for EPA standards and application-specific fitment on OBDII vehicles. Part number 16741 is intended for federal-emissions use only and is not legal for sale or use in California and other CARB-compliant states. It is legal in New York and Maine on EPA federal-emission-equipped vehicles only, subject to state regulations.