Walker 215-2250 Fuel Injection Idle Air Control Valve

Walker Valve Only Idle Air Control Valve

Walker Products Part Number 215-2250 is an OE replacement fuel injection idle air control valve for stable idle control on select Honda applications. It regulates bypass air around the throttle plate to help maintain consistent engine speed during warm-up, load changes, and deceleration.

The Walker Valve Only line focuses on direct-fit idle air control service parts built to OE specifications for airflow response, pintle shape, stepper motor behavior, and voltage range. This makes 215-2250 a practical choice for restoring idle quality on 2003-2005 Honda Accord and 2003-2006 Honda Element applications.

Key Features

• OE replacement fuel injection idle air control valve
• Direct-fit design for the original throttle body or intake housing
• 3-terminal male spade connection with factory-style hookup
• Plastic housing with black finish
• Gasket or seal included
• 3 mounting holes for OE-style installation
• Built for idle airflow control during warm-up and accessory load changes
• Walker Part Number 215-2250

Detailed Description

Walker 215-2250 is engineered to regulate bypass air so the ECU can maintain a steady idle under changing engine conditions. It is built with high-temperature-resistant materials and sealed against fuel vapors and moisture for the engine bay environment. For drivers servicing a Honda Accord idle air control valve or replacing a Honda Element IAC valve, this part is designed to match OE fit and electrical connection requirements.

Fits 2003-2005 Honda Accord, N/A. Fits 2003-2006 Honda Element, N/A. This part cross-references Walker Products 215-2250 for the same application.

Common Issues It Can Address

• Erratic or unstable idle speed
• Engine stalling at stops or during deceleration
• Hard starting after cold soak or warm-up
• Idle speed changes when A/C or power steering loads the engine
• Check engine light related to idle air control performance

Installation Notes and Tips

Confirm the throttle body or intake housing matches the OE mounting pattern and 3-terminal spade connector before installation. Replace the gasket or seal as part of the service, and inspect the throttle body passages for carbon buildup that can affect idle airflow. After installation, clear any stored fault codes and verify idle quality at cold start and at operating temperature.

Quality Assurance

Walker Products builds this idle air control valve as an OE replacement component with specifications matched to the original part for airflow control and electrical response. The design is intended to restore factory-style idle regulation on supported Honda applications.