Walker 270-1079 Ignition Coil Connector

OE-Style Ignition Coil Connector

Walker 270-1079 is an OE replacement ignition coil connector built to restore a secure electrical connection where the original harness plug is damaged, heat-affected, or corroded. It uses a molded OE-style housing with pre-terminated leads for a factory-style repair on Honda and Acura ignition systems.

Key Features

• OE-style ignition coil connector for direct harness repair
• Pre-terminated leads simplify crimp or solder splicing
• 3-terminal female blade connector design
• 12-gauge wire with copper conductors and OE-spec insulation
• Heat-, oil-, and chemical-resistant construction for engine bay use
• 184.15 in. wiring harness length for flexible routing during repair

Detailed Description

Walker 270-1079 is engineered for ignition coil connector repair on a wide range of Acura and Honda applications, including Honda Civic, Accord, CR-V, Odyssey, Pilot, Ridgeline, S2000, Element, and Acura MDX, TL, TSX, RSX, CL, RL, and RDX. This part number 270-1079 restores the factory-style connection point between the vehicle harness and the ignition coil, helping maintain consistent electrical contact in high-heat areas under the hood. The connector housing is molded to match OE fitment, while the copper wire and insulation are selected for current capacity, flexibility, and resistance to common underhood contaminants.

This part cross-references no listed aftermarket part numbers for the same application.

Common Repair Uses

• Broken or brittle ignition coil connector housing
• Corroded terminals causing intermittent coil signal loss
• Heat-damaged wiring near the engine bay
• Misfire diagnosis traced to poor coil connector contact
• Harness repair after rodent or abrasion damage

Installation Notes

Install using standard crimp or solder repair methods and match the existing harness wiring before final connection. Verify terminal orientation and secure the splice away from exhaust heat, moving components, and sharp edges. Walker 270-1079 is a direct-fit repair connector for OE-style service work on Honda and Acura ignition coil circuits.

Quality Assurance

Walker Products builds these electrical pigtails as OE replacement components using materials selected to meet factory-style electrical and environmental demands. The connector is designed for dependable long-term service in areas exposed to heat, oil, and chemical contamination.