Walker 270-1119 Ignition Coil Connector

Walker 270-1119 Ignition Coil Connector

Walker 270-1119 is an OE-style ignition coil connector built for reliable electrical repair in Hyundai, Kia, Volvo, Subaru, and select Cadillac applications. It uses a female connector housing with male spade terminals and factory-style lead construction to restore a secure connection at the coil or related engine sensor location.

Key Features

• OE replacement ignition coil connector for electrical harness repair
• Female connector with male spade terminals
• 4-terminal design for factory-style fitment
• Pre-terminated leads for crimp or solder repair methods
• Copper wire and insulation selected for heat, oil, and chemical resistance
• Walker part number 270-1119 for direct catalog lookup

Detailed Description

Walker Products electrical pigtails are built to replace damaged connector ends without modifying the mating component. Part number 270-1119 is engineered with molded OE-style housing and pre-terminated leads to match factory electrical connections on ignition coils and related systems. This connector is used across a wide range of vehicles, including Hyundai Elantra, Hyundai Sonata, Kia Optima, Kia Sorento, Volvo S60, and Volvo XC90 applications listed in the fitment data. The design supports dependable current transfer in areas exposed to engine heat, vibration, corrosion, and fluid contamination.

For buyers searching for a Hyundai Elantra ignition coil connector, Kia Optima coil pigtail, or Volvo S60 electrical connector repair, this part provides a factory-style service solution. Walker 270-1119 is also listed for select Subaru Forester, Subaru Impreza, Subaru Legacy, and Subaru Outback air charge/intake air temperature sensor applications, as well as certain Cadillac SRX, STS, and XLR models.

Common Repair Uses

• Broken or heat-damaged ignition coil connector housing
• Corroded or loose electrical terminals at the coil connector
• Intermittent misfire caused by poor harness contact
• Wiring repair after engine bay heat or chemical exposure
• Connector replacement during drivability or emissions diagnostics

Installation Notes

Install using standard crimp or solder repair methods and match the existing harness wiring before final connection. Verify terminal orientation and connector indexing against the original part before splicing. For fitment-specific service, confirm the vehicle year, make, model, and any listed notes such as intake manifold location or VIN breakpoints before installation.

Quality Assurance

Walker electrical pigtails are manufactured as OE replacement components with factory-style housings, copper conductors, and insulation selected to meet OE-level electrical and environmental requirements. Part number 270-1119 is built for long-term connector repair in demanding underhood conditions.