Walker 35775 Exhaust Clamp - Muffler To Connector, Muffler To Tail Pipe or Rear

Walker 35775 Exhaust Clamp Overview

Walker 35775 is a steel U-bolt exhaust clamp with a zinc finish, built for 5-inch pipe applications. It is a regular-grade clamp with a 0.375-inch bolt diameter, 6.375-inch width, and hex nut design for secure exhaust system fastening.

For drivers searching for a Walker exhaust clamp for Ford F-150 or Chevrolet Silverado exhaust repair, this part number provides an OE-style hardware solution backed by Walker’s emissions-control manufacturing experience.

Key Features

• Steel construction for exhaust system hardware use
• Zinc finish for added corrosion resistance
• U-bolt clamp design for 5-inch pipe diameter
• 0.375-inch bolt diameter with hex nut type
• 6.375-inch width for broad clamping coverage
• Walker part number 35775 for easy identification

Product Details

Walker 35775 is an exhaust clamp designed for securing exhaust tubing in repair and replacement applications. Its steel body and zinc coating support dependable fastening in demanding undercar conditions, while the U-bolt layout helps maintain a tight connection at the pipe joint. Walker’s OE-focused manufacturing background supports consistent fit and dependable aftermarket emissions hardware.

This part cross-references AP Exhaust H500PZ for the same application. If you are comparing exhaust clamp options for Ford F-150 or Chevrolet Silverado service work, Walker 35775 is a direct hardware reference to keep on hand during exhaust repair planning.

Common Uses

• Securing exhaust pipe joints after muffler or pipe replacement
• Replacing a worn or corroded exhaust clamp
• Restoring a tight seal at a 5-inch exhaust connection
• Addressing exhaust leaks caused by loose hardware
• Supporting routine exhaust system maintenance on Ford F-150 and Chevrolet Silverado applications

Installation Notes

Verify pipe diameter before installation to confirm a 5-inch exhaust connection. Clean the mating surfaces and inspect the pipe ends for damage, rust, or distortion before tightening the clamp. Use proper exhaust service procedures and torque the hardware evenly to help maintain a secure seal.

Quality Assurance

Walker develops emissions-control components with OE-style fit, appearance, and dependability in mind. Part number 35775 reflects that approach for aftermarket exhaust hardware and replacement clamp service.