Walker 44812 Exhaust Tail Pipe

Walker 44812 Exhaust Tail Pipe

Walker 44812 is a specific-fit exhaust tail pipe made from aluminized steel for durability and corrosion resistance. It is built with precision bending and fixture checking to help deliver a precise fit for straightforward installation on select Chevrolet S10 Blazer and GMC S15 Jimmy applications.

Key Features

• Aluminized steel construction for long-term exhaust durability
• 2-inch inlet outside diameter and 2-inch outlet outside diameter
• 45-inch overall length
• Specific-fit design for direct replacement applications
• Pipe connection inlet with spout outlet
• Regular grade replacement exhaust tail pipe

Detailed Fitment and Application

Walker 44812 is an exhaust tail pipe for drivers replacing a worn, rusted, or damaged rear exhaust section on select trucks and SUVs. It is engineered for direct-fit service on 1983-1991 Chevrolet S10 Blazer and 1983-1991 GMC S15 Jimmy applications, with additional 1988-1989 Chevrolet S10 Blazer and 1988-1989 GMC S15 Jimmy listings that require 35940. This part number, 44812, is a practical OE-style replacement for restoring exhaust routing and outlet alignment on these vehicles.

This part cross-references AP Exhaust 44766 and Four Seasons 54758 for the same application.

Common Problems This Part Can Address

• Rust-through or corrosion in the rear exhaust pipe
• Cracked or damaged tail pipe sections
• Exhaust leaks caused by deterioration at the pipe connection
• Poor exhaust routing after a previous repair
• Fitment issues when replacing a non-specific or modified pipe

Installation Notes and Tips

Verify the inlet and outlet diameters before installation to confirm the 2-inch connection size. Because this is a specific-fit exhaust tail pipe, compare the vehicle’s existing routing and mounting points to the listed application before installation. For 1988-1989 Chevrolet S10 Blazer and GMC S15 Jimmy models, confirm the required 35940 note before ordering. Walker 44812 is intended for direct replacement use on the listed Chevrolet S10 Blazer and GMC S15 Jimmy applications.

Quality Assurance

Walker manufactures this tail pipe from aluminized steel and uses precision bending plus fixture checking to help maintain consistent fit and form. The result is a replacement exhaust component built for accurate alignment and dependable service on the specified applications.