Walker 47845 Exhaust Resonator and Pipe Assembly

Walker 47845 Exhaust Resonator and Pipe Assembly

Walker 47845 is an exhaust resonator and pipe assembly built for OE-style fit, flow, and sound control. It is designed for the 2010-2011 Honda CR-V and uses aluminized steel construction with welded flange connections for a direct replacement-style installation.

For buyers searching for a 2010 Honda CR-V exhaust resonator and pipe assembly or a 2011 Honda CR-V resonator replacement, this part number 47845 provides a vehicle-specific solution that follows the original system layout.

Key Features

• Fits 2010-2011 Honda CR-V, N/A
• Walker part number 47845
• Exhaust resonator and pipe assembly for OE-style replacement
• Steel pipe and steel body construction
• Aluminized finish for corrosion resistance
• Round resonator body with 16-inch body length
• Overall length: 73 inches
• 1 inlet with 3-bolt welded flange
• 1 outlet with 2-bolt welded flange

Detailed Description

Walker 47845 is engineered to match the original exhaust system’s fit, performance, and sound characteristics. The resonator uses precise tuning to support smooth exhaust flow while helping maintain OE-style sound quality on the Honda CR-V. Its steel construction and aluminized finish are suited for replacement of a worn or damaged resonator and pipe assembly in the factory exhaust path.

This part cross-references AP Exhaust 78289 and 284-623 for the same application. If you need a Walker 47845 exhaust resonator for a 2010-2011 Honda CR-V, this assembly is built around the original connection style and dimensions to simplify replacement planning.

Common Problems This Part Can Address

• Exhaust noise from a damaged or rusted resonator assembly
• Restricted exhaust flow caused by internal deterioration
• Leaks at worn flange connections
• Corrosion in the factory resonator and pipe section
• Loss of OE-style exhaust tone after system wear

Installation Notes and Tips

Verify the vehicle application before ordering: Fits 2010-2011 Honda CR-V, N/A. Compare the inlet and outlet flange styles, overall length, and body dimensions to the original assembly before installation. Because this is a welded flange exhaust component, proper alignment of the exhaust system is important for sealing and fitment.

Quality Assurance

Walker designs this resonator to fit, perform, and sound like the original system, using tuning methods aimed at maintaining factory-style exhaust characteristics. The aluminized steel construction supports long-term service in a replacement exhaust application.