Walker 50367 Catalytic Converter - Front

Walker EPA Direct-Fit Catalytic Converter

Walker EPA 50367 is a direct-fit catalytic converter built for front exhaust placement on select Ram and Dodge Ram 1500 applications. It is designed for OBDII vehicles and uses a stainless steel body with a round converter housing for a direct replacement path.

For buyers searching for a 2009-2013 Ram 1500 front catalytic converter or a 2011-2013 Ram 1500 front catalytic converter, this Walker EPA unit matches the listed fitment and exhaust connection style. The Walker EPA line focuses on EPA-compliant replacement coverage for import and domestic vehicles.

Key Features

• Part number 50367
• Walker EPA Ultra Direct-Fit catalytic converter
• Direct fit for front left and front right positions
• Stainless steel body with round construction
• 3-inch inlet diameter and 3-inch outlet diameter
• 2-bolt loose flange with spherical flare inlet connection
• Pre-catalyst and midbed oxygen sensor locations
• EPA standards-focused replacement design

Fitment and Application

Fits 2011-2013 Ram 1500, front. Fits 2009-2010 Dodge Ram 1500, front. This part is listed for Fed. and Calif. emission models, but it is not legal for sale or use in California and other CARB-compliant states. It is legal in New York and Maine on EPA Federal Emission Equipped Vehicles only.

Walker 50367 is a direct-fit catalytic converter for drivers replacing a front exhaust converter on a Ram 1500 or Dodge Ram 1500 with the specified emission setup. The overall length is 31 inches, with a 9-inch body length, 4-inch body height, and 4-inch body width for a factory-style exhaust layout.

Common Repair Uses

• Check engine light related to catalyst efficiency
• Failed emissions inspection tied to converter performance
• Restricted exhaust flow from a worn catalytic converter
• Exhaust leak at the front converter connection
• Replacement for a damaged or corroded front exhaust converter

Installation Notes

Exhaust gasket is recommended during installation. Verify the vehicle’s emission certification, engine configuration, and front converter location before ordering. Confirm the 2-bolt loose flange with spherical flare inlet connection and 3-inch pipe sizing against the original exhaust assembly for proper alignment.

Quality Assurance

Walker EPA catalytic converters are built for EPA-focused replacement use on OBDII vehicles and are engineered as direct-fit emissions components. This part cross-references AP Exhaust 645231 for the same application. Part number 50367 is also referenced by Walker for this fitment family.