Walker 54136 Exhaust Tail Pipe - Front

Walker 54136 Exhaust Tail Pipe

Walker 54136 is a specific-fit exhaust tail pipe made from aluminized steel for durability and corrosion resistance. It is built with precision benders and fixture checking to support a precise fit on select 1995 Chevrolet and GMC vans with a 3-inch pipe connection.

Key Features

• Aluminized steel construction for long-term exhaust durability
• 3-inch inlet inside diameter and 3-inch outlet outside diameter
• 41-inch overall length for the listed tail pipe extension applications
• Specific-fit design for direct replacement on confirmed vehicles
• Precision-formed and fixture checked for consistent alignment

Detailed Description

Walker 54136 is an exhaust tail pipe engineered for select 1995 Chevrolet G10, G20, and G30, as well as 1995 GMC G1500, G2500, and G3500 applications. It is a direct-fit exhaust tail pipe extension for front-position installations, with notes indicating that welded assemblies require replacement of all required parts. This part cross-references Gates 38627 for the same application. The aluminized steel finish helps the pipe stand up to everyday exhaust heat and road exposure while maintaining the dimensions needed for proper exhaust routing.

For buyers searching for a 1995 Chevrolet G10 exhaust tail pipe, 1995 GMC G2500 tail pipe extension, or Walker 54136 exhaust pipe replacement, this part matches the listed vehicle-specific fitment and connection sizes. The 3-inch pipe connection at both inlet and outlet supports a straightforward replacement where the original exhaust path uses the same diameter.

What It Helps Address

• Rust or corrosion in the rear exhaust section
• Cracked or damaged tail pipe extension sections
• Exhaust leaks caused by deteriorated pipe material
• Improper exhaust routing after prior repair work
• Fitment issues when replacing a worn factory tail pipe on listed vans

Installation Notes

Confirm the vehicle is one of the listed 1995 Chevrolet or GMC applications before ordering. This part is specified for front-position use and a 3-inch pipe connection. If the original system uses a welded assembly, replace all required parts to complete the repair and maintain proper alignment.

Quality Assurance

Walker manufactures this pipe with precision benders and fixture checking to support accurate fitment and consistent installation on the confirmed applications.