Walker 54524 Catalytic Converter - Right

Walker EPA Direct-Fit Catalytic Converter

Walker EPA 54524 is a direct-fit catalytic converter built for specific applications on 2000-2001 Ford F-150 right-side exhaust systems. It is designed for OBDII vehicles and uses a stainless steel body with a ceramic substrate for EPA-compliant replacement performance.

The Walker EPA product line focuses on direct-fit exhaust replacement parts that match the original routing and connection style for easier service on import and domestic vehicles. For this application, 54524 is built to align with the factory exhaust layout on the Ford F-150.

• Direct-fit replacement for 2000-2001 Ford F-150, right
• EPA-compliant design for federal emissions applications
• Stainless steel body construction
• Ceramic substrate material
• Pre- and post-catalyst oxygen sensor location
• Front round and rear standard oval body shape
• Pipe connection outlet with 2-bolt loose flange inlet design

Fitment Details

Fits 2000-2001 Ford F-150, right. This application is listed for Federal and California emission models, with the note that it is not legal for sale or use in California and other CARB-compliant states. It is legal in New York and Maine on EPA Federal Emission Equipped Vehicles only. Exhaust gasket is recommended.

Walker 54524 is a direct replacement for the right-side converter location on the Ford F-150, with inlet diameters of 2.5 inches and 3 inches and an overall length of 48.75 inches. The unit is built to restore exhaust flow through the catalytic section while maintaining the factory-style connection points and sensor placement. This part cross-references Eastern Catalytic (e.g., 30377, 30459) for the same application.

Common Repair Symptoms

• Check engine light related to catalyst efficiency
• Failed emissions inspection
• Restricted exhaust flow from a worn converter
• Rattling or damaged catalyst substrate
• Exhaust odor from a deteriorated converter

Installation Notes

Verify the vehicle’s emission certification and state regulations before installation. This converter uses a specific fit design with 2-bolt loose flange and pipe connections, so matching the inlet and outlet configuration is important. An exhaust gasket is recommended during installation, and the pre- and post-catalyst oxygen sensor locations should be checked against the vehicle’s original setup.

Quality Assurance

Walker EPA catalytic converters are built to meet EPA standards for listed applications and are intended for direct replacement use on approved vehicles. Part number 54524 is engineered for fitment accuracy and emissions-system compatibility within the stated application range.